Sennheiser Electronic Corp SDCW9000AP Manual De Usuario
DE
EN
FR
IT
ES
NL
WiCOS ehemals SDCw 9000 | Korrekturexemplar 10 | 03.03.09
29
Switching the components on/off
Switching the components on/off
To switch the WiCOS conference system on, proceed as follows:
1. Switch the access point on (see next chapter).
2. Switch the conference units on (see page 31).
The connection is automatically established. The conference system
loads the last configuration used (see next chapters).
loads the last configuration used (see next chapters).
Switching the access point on/off
To switch the access point
on
:
왘
Set the on/off switch
m
to position “
1
”.
The last configuration used is loaded. The 3 status indicators
^
provide the following information:
You can use the factory default settings or adapt the configuration to your
needs (see page 43):
needs (see page 43):
m
`
Blue LED 1
Operating mode of the access point
flashes slowly
integrated operation (slave mode)
lights up
stand-alone operation
^
Red LED 2
Link quality (RF signal quality)
off
excellent
flashes slowly
good
flashes rapidly
fair
lights up
low
^
Blue LED 3
Connection status with the conference units
flashes rapidly
no connection
lights up
connection with at least 1 conference unit
Configuration
Function/Meaning
Detailed
information
information
Network settings
(IP address)
(IP address)
To load the web server and to
modify the configuration
modify the configuration
see page 48
Country settings for radio
communication
communication
To set country-specific limit
values for radio frequencies and
transmission power
values for radio frequencies and
transmission power
see page 50
Password protection
To protect the web server from
unauthorized access
unauthorized access
see page 51
RF signal strength
To set the transmission power
see page 52
Radio frequency
To set the radio frequencies to be
used in the 2.4 GHz and 5 GHz
frequency bands
used in the 2.4 GHz and 5 GHz
frequency bands
see page 52