OMG plc VICP1 Manual De Usuario

Origin 
Setup & 
Maintenance 
Guide 

Vicon Motion Systems Ltd.

04-Sep-2018

Page 32 of 45

FCC Notice and Cautions

The device may cause TV or radio interference if used in close proximity to 

receiving equipment. The FCC can require you to stop using the equipment 

if such interference cannot be eliminated.

Cautions: Any changes or modifications to your device not expressly 

approved by Vicon Motions Systems Ltd could void your warranty for this 

equipment and void your authority to operate this equipment. Only use 

approved batteries. The use of any unauthorized accessories may be 

dangerous and void the device warranty if said accessories cause damage 

or a defect to the device. Although your device is quite sturdy, it is a 

complex piece of equipment and can be broken. Avoid dropping, hitting, 

bending or sitting on it.

This equipment complies with FCC radiation exposure limits set forth for an 

uncontrolled environment. End users must follow the specific operating 

instructions for satisfying RF exposure compliance. This transmitter must 

not be co-located or operating in conjunction with any other antenna or 

transmitter.

The published FCC IDs are Beacon DMR-VICMSU1 and Pulsar LED Clusters

DMR-VICP1.

For Canadian customers

Under Industry Canada regulations, this radio transmitter may only operate 

using an antenna of a type and maximum (or lesser) gain approved for the 

transmitter by Industry Canada.

To reduce potential radio interference to other users, the antenna type and 

its gain should be so chosen that the equivalent isotropically radiated 

power (e.i.r.p.) is not more than that necessary for successful 

communication.

This device complies with Industry Canada licence-exempt RSS standard(s). 

Operation is subject to the following two conditions: (1) this device may not 

cause interference, and (2) this device must accept any interference, 

including interference that may cause undesired operation of the device.

Conformément à la réglementation d'Industrie Canada, le présent émetteur 

radio peut fonctionner avec une antenne d'un type et d'un gain maximal 

(ou inférieur) approuvé pour l'émetteur par Industrie Canada.