Checkpoint Systems Inc. EVOLVEF10 Manual De Usuario
F10 Installation Manual
Rev. *60
51 of 71
Figure 5.14 Alarm Patterns Enabled
8. At the bottom of the Patterns tab are the Update and Add buttons used to configure Patterns.
If Add is chosen, the new alarm pattern appears in the list of existing alarm pattern (Light and
Sounder) as shown in Figure 5.15 below.
Sounder) as shown in Figure 5.15 below.
Figure 5.15 Previously Established Alarm Patterns
9. To Add, select the desired settings from the pattern settings created (refer to Step 15). After
the alarm pattern settings are entered according to the customer’s specifications, add this
specific alarm pattern as a new alarm by clicking Add.
specific alarm pattern as a new alarm by clicking Add.
10. To Update, click and highlight the existing alarm pattern (that needs to be overwritten), then
select the desired settings and click Update.
Note: If Update is chosen, this overwrites the existing alarm pattern to the new parameters.