Checkpoint Systems Inc. EVOLVES10 Manual De Usuario

Descargar
Página de 143
Chapter 2 – SocketModem (MT5600SMI & MT5656SMI) 
Multi-Tech Systems, Inc. Universal Socket Hardware Guide for Developers (S000342D) 
47 
 
Parallel Configuration 
Note:
 The parallel configuration is not compatible with the serial universal socket. 
The parallel interface SocketModem uses a 22-pin interface to provide an on-board DAA with tip and ring 
connections, audio circuit for call-progress monitoring, and parallel interface
.
 
 
Parallel SocketModem Pinout 
 
Parallel Pin Descriptions 
Pin #  Signal 
Name 
In Out 
Type 
Description 
Tip I/O 
Telephone Line Interface – TIP  
Ring I/O 
Telephone Line Interface – RING 
24 
–RESET I  Modem Reset (CMOS input with pull-up). The active low –RESET input 
resets the SocketModem logic and returns the AT command set to the original 
factory default values or to "stored values" in NVRAM. 
The modem is ready to accept commands within 6.5 seconds of power-on or 
reset.  Reset must be asserted for a minimum of 15ms. 
25 
A1  
Host Bus Address Line 1 
26 
DGND GND 
Digital Ground 
27 
D7 O 
Host Bus Data Line 7 
29 
D2 O 
Host Bus Data Line 2 
30 
INT O 
Host Bus Interrupt Line (Active High, Resets on Low) 
31 
A0 I 
Host Bus Address Line 0 
32 
–WT I 
Host Bus Write.  When low, allows host to write to SocketModem.  
33 
–RD I 
Host Bus Read. When low, allows host to read from SocketModem.  
34 
A2 I 
Host Bus Address Line 2 
35 
D4 O 
Host Bus Data Line 4 
36 
D5 O 
Host Bus Data Line 5 
37 
D0 O 
Host Bus Data Line 0 
38 
D1 O 
Host Bus Data Line 1 
39 
D3 O 
Host Bus Data Line 3 
40 
–CS I 
Host Bus Chip Select (Active Low)   
41 
D6 O 
Host Bus Data Line 6 
61 
VCC PWR 
3.3 V or 5 V Supply (depends upon model). 
63 
AGND GND Analog Ground. This is tied common with DGND on the SocketModem.  To 
minimize potential ground noise issues, connect audio circuit return to AGND. 
64 
SPKR O Speaker – Call monitor.