Checkpoint Systems Inc. FISOCKS Manual De Usuario
13-14
I L S O p e n P l u s 3 . 0 I n s t a l l a t i o n M a n u a l
6
Set the new paper roll into the printer, and pull on the leading edge of the paper from
the bottom toward you (as shown below)
the bottom toward you (as shown below)
Figure 13.14
Self-Checkout Station Printer - New Roll Installation
7
Make sure there is enough excess paper so that approximately 1/8” of paper is coming
through when you close the paper roller bar assembly.
through when you close the paper roller bar assembly.
8
Close the paper roller bar assembly by pushing it down until it snaps closed securely.
9
As soon as you close the paper roller bar assembly, the paper will automatically feed
and cut off the end of the paper.
and cut off the end of the paper.
10
Remove and discard the excess piece of paper that was cut off in the previous step.
11
Replace the printer access cover, and push down to secure it to the unit with the hook
and loop fasteners.
and loop fasteners.
Note The paper will feed through the small slit opening in the printer access cover during self checkout
transactions.