Checkpoint Systems Inc. STRATAEX Manual De Usuario
TUNING PROCEDURE TR4022
____________________________________________________________________________________________________________________________
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY.
Rev. 00
Page
10
4.0 LED
DEFINITIONS
System Status Indicators
DS1 – Inhibit Indicator
This LED indicates that a condition exists that would prevent normal detection of a tag,
typically excessive environmental noise. (At the end of an alarm cycle the inhibit LED
will light momentarily)
typically excessive environmental noise. (At the end of an alarm cycle the inhibit LED
will light momentarily)
DS2 – Alarm
This LED indicates the system is alarming (useful for when the sounder and lights are
disconnected).
disconnected).
DS3 - Heartbeat
This LED indicates the system is operating normally. This LED blinks at an approximate
1 Hz rate. If the led is not blinking, it is a catastrophic failure and the board should be
replaced.
1 Hz rate. If the led is not blinking, it is a catastrophic failure and the board should be
replaced.
DS4 – Transmitter Status
This LED indicates the ‘power’ level of the transmitter, this led is normally on. When
the system detects an event above the alarm threshold it reduces the transmitter power
output and extinguishes the led.
the system detects an event above the alarm threshold it reduces the transmitter power
output and extinguishes the led.
DS5, DS 6 – Spare
(During development DS5 indicates the status of the external sync on power up)
(During development DS6 indicates the status of the external rf on power up)
(During development DS6 indicates the status of the external rf on power up)
DS7 – Q Disqualification Indicator
This LED indicates the system has detected a resonance however the ‘Q” of the resonance is
either above or below the limits selected by the ‘Q’ qualification switches.
either above or below the limits selected by the ‘Q’ qualification switches.
Internal and external Sync and RF indicators – DS8, DS9, and DS10
On power up or reset the system ‘reads’ the sync, rf, and switch status and configures the
board appropriately. The configuration algorithm is as follows.
M/S
Switch
(SW 6-1)
External
RF
Source
External
Sync Source
Condition
DS10
(Master)
Green
DS9
(Sub-master)
yellow
DS8
(Slave)
Red
Master
Absent
Absent
OK – self generating sync and RF
(system is a master)
(system is a master)
On
Off
Off
Master
Absent
Present
ERROR
Off
Blink
Off
Master
Present
Absent
ERROR
Blink
Off
Off
Master
Present
Present
ERROR
Off
Off
Blink
Slave
Absent
Absent
ERROR
Blink
Blink
Blink
Slave
Absent
Present
OK – External sync and Self
generating RF (system is a sub-
master)
generating RF (system is a sub-
master)
Off
On
Off
Slave
Present
Absent
ERROR
Blink
Blink
Blink
Slave
Present
Present
OK – External sync and External
RF (system is a slave)
RF (system is a slave)
Off
Off
On