Checkpoint Systems Inc. TPRO7200 Manual De Usuario
INSTALLATION PROCEDURE,
TPRO7100 AND TPRO7200
____________________________________________________________________________________________________________________________
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY.
Dwg. No. 813910
Rev. *60
Page 10
Refer to the SBC board schematic for the following:
1. Jumper pins 2 & 3 of J5 (select “WDOG”)
2. Jumper pins 1 & 2 of J17 (select “+5V”)
3. Jumper pins 2 & 3 of J24 (select “COM2”)
4. Jumper J14 (Connects the RTC battery)
5. Jumper J20 pins 11 &12 (selects IRQ0 for the PC104 sound card)
6. Jumper J18, J21, and J22 to the “RS-232” position (pin 2 to pin 3)
2. Jumper pins 1 & 2 of J17 (select “+5V”)
3. Jumper pins 2 & 3 of J24 (select “COM2”)
4. Jumper J14 (Connects the RTC battery)
5. Jumper J20 pins 11 &12 (selects IRQ0 for the PC104 sound card)
6. Jumper J18, J21, and J22 to the “RS-232” position (pin 2 to pin 3)
10.2 MISCELLANEOUS SETTINGS
Set switches SW2 1 and SW2 3 to “ON” and SW2 2 to off (4 is not used).
11.0 TPRO7100 And TPRO7200 Antenna Tuning Procedure
Tuning the TPRO7100 and TPRO7200 antenna involves adjusting a piston capacitor on the
antenna.
antenna.
1. Supply power to the TPRO7100 or TPRO7200 using the appropriate wall pack.
2. Adjust the piston capacitor to maximize the distance from the antenna that the tag reads. You
2. Adjust the piston capacitor to maximize the distance from the antenna that the tag reads. You
will know that a tag has been read when you see the red LED on the side of the reader blink.
This distance should be > 8 inches when the tag is parallel to the antenna (you should be able
to adjust for at least a 10 inch read range).
This distance should be > 8 inches when the tag is parallel to the antenna (you should be able
to adjust for at least a 10 inch read range).