Mindray DS USA Inc. WT0707-00000 Manual De Usuario
Panorama™ Operating Instructions
0070-10-0690-01
xv
Warnings, Precautions and Notes
Introduction
CAUTION:
The Telepack with Nonin SpO
2
module has motion tolerant
software that minimizes the likelihood of motion artifact
being misinterpreted as good pulse quality. In some
circumstances, however, the Telepack with Nonin SpO
being misinterpreted as good pulse quality. In some
circumstances, however, the Telepack with Nonin SpO
2
module may still interpret motion as good pulse quality. This
applies to all available outputs (i.e. SpO
applies to all available outputs (i.e. SpO
2
, HR, Pleth, PPG).
CAUTION:
A functional tester cannot be used to assess the accuracy of
the pulse oximeter probe or a pulse oximeter monitor.
the pulse oximeter probe or a pulse oximeter monitor.
CAUTION:
The Telepack with Nonin SpO
2
module complies with
International Standard IEC 60601-1-2:2005 for
electromagnetic compatibility for medical electrical
equipment and/or systems. This standard is designed to
provide reasonable protection against harmful interference
in a typical medical installation. However, because of the
proliferation of radio-frequency transmitting equipment and
other sources of electrical noise in healthcare and other
environments, it is possible that high levels of such
interference due to close proximity or strength of a source
might disrupt the performance of this device. Medical
electrical equipment needs special precautions regarding
EMC, and all equipment must be installed and put into
service according to the EMC information specified in this
manual.
electromagnetic compatibility for medical electrical
equipment and/or systems. This standard is designed to
provide reasonable protection against harmful interference
in a typical medical installation. However, because of the
proliferation of radio-frequency transmitting equipment and
other sources of electrical noise in healthcare and other
environments, it is possible that high levels of such
interference due to close proximity or strength of a source
might disrupt the performance of this device. Medical
electrical equipment needs special precautions regarding
EMC, and all equipment must be installed and put into
service according to the EMC information specified in this
manual.
CAUTION:
Datascope requires that the designated cleaning plug
(P/N 0003-00-0055) be used when cleaning and
disinfecting the Nonin SpO
(P/N 0003-00-0055) be used when cleaning and
disinfecting the Nonin SpO
2
module. If fluids enter the
device, it may affect the functionality of the module or
render it unusable.
render it unusable.
CAUTION:
In compliance with the European Directive on Waste
Electrical and Electronic Equipment (WEEE) 2002/96/EC, do
not dispose of this product as unsorted municipal waste.
Electrical and Electronic Equipment (WEEE) 2002/96/EC, do
not dispose of this product as unsorted municipal waste.
CAUTION:
It is important to notify Datascope Service personnel when
the system event message “System Service required -
Contact Datascope or Authorized Datascope Distributor
(300).” is displayed. This message indicates that while data
was being written to or read from the system hard drive, an
error was detected. Until service personnel correct this issue,
patient data may be lost (for example, demographic
information, alarm configurations, and historical patient
data). Real time parameter monitoring and alarm checking
will not be affected by this message. This message will be
displayed until reset by service personnel.
the system event message “System Service required -
Contact Datascope or Authorized Datascope Distributor
(300).” is displayed. This message indicates that while data
was being written to or read from the system hard drive, an
error was detected. Until service personnel correct this issue,
patient data may be lost (for example, demographic
information, alarm configurations, and historical patient
data). Real time parameter monitoring and alarm checking
will not be affected by this message. This message will be
displayed until reset by service personnel.