CPAC Systems AB BTGW Manual De Usuario
BB2
Title:
Revision:
Classification:
Page:
CPAC-BTGW: General Guidelines
- Installation and Operation
- Installation and Operation
PA1
Open within project
5(13)
3.
Installation
3.1
CPAC-BTGW unit
Picture #1 CPAC-BTGW
– exterior view
3.2
Mounting requirements - unit
The CPAC-BTGW unit shall normally be mounted under the dash board at the boat helm station, or in
the engine compartment by using tie wraps included in kit. Boat builder or VP dealer to decide where to
mount the BTGW.
the engine compartment by using tie wraps included in kit. Boat builder or VP dealer to decide where to
mount the BTGW.
The unit can be mounted horizontally or vertically.
No hot surfaces shall be close to or come in contact with the unit and cables.
No hot surfaces shall be close to or come in contact with the unit and cables.
No moving parts shall be allowed touch the cables or the unit
3.3
Mounting requirements - cables
The cables shall be strapped to avoid tension (push/pull/torque) on the connectors.
Cable and connector mounting and clamping shall follow “VP guidelines”
The cables shall normally be routed away from electrical disturbance sources like radio
The cables shall normally be routed away from electrical disturbance sources like radio
transmitters, electrical motors, power inverters etc.
All electrical equipment within 2 m from the cables shall comply with the Volvo EMC directives
6-pin Deutsch connector: Connect to
multilink or J1939 bus depending on
installation.
multilink or J1939 bus depending on
installation.
5-pin Device Net Micro-C connector:
Connect to NMEA network.
Connect to NMEA network.
Fasten BTGW with tie wraps by using
holes in box
holes in box
Bluetooth code for connection to app.