Transition Networks CFETF1013-110 Prospecto
Transition Networks, Inc.
Worldwide Headquarters:
10900 Red Circle Drive
Minnetonka, MN 55343 USA
Worldwide Headquarters:
10900 Red Circle Drive
Minnetonka, MN 55343 USA
tel: 952.941.7600 / 800.526.9267
fax: 952.941.2322
info@transition.com
http://www.transition.com
fax: 952.941.2322
info@transition.com
http://www.transition.com
©2010 Transition Networks, Inc.
All trade marks are the property of their respective owners.
Technical information is subject to change without notice.
All trade marks are the property of their respective owners.
Technical information is subject to change without notice.
AUTO NEG
AUTO CROSS LINK PASS THRU LINK RESTORE
AUTO
UPGRADE
REMOTE FIRMWARE
Deploy fiber in a strategic and economical
manner by using Fast Ethernet converters,
which can extend to distances that copper
cannot reach.
manner by using Fast Ethernet converters,
which can extend to distances that copper
cannot reach.
CFETF10xx-110
point system™ slide-in-module media converter
Integrate fiber into a 100BASE -TX
copper environment
Provides a fiber interface when connected
to devices with RJ-45 ports
100BASE-TX to 100BASE-FX [Class A]
Fast Ethernet
see also:
Fast Ethernet Stand-Alone Media Converters
Fast Ethernet Class A Media Converter
Features
Round trip delay of only 40 bit times, far below
the Class II rating of 92 bit times
Auto-Negotiation
AutoCross™
Link Pass Through
Automated Link Restoration
Remote Firmware Upgrade
Can be used with any Point System™ Chassis
Specifications
Standards
IEEE Std. 802.3
3-position Jumper
Hardware: Converter mode is determined by
4-position switch settings
Software: Converter mode is determined by most
recently saved on-board microprocessor settings
4-position switch settings
Software: Converter mode is determined by most
recently saved on-board microprocessor settings
4-position Switch
1st) Auto-Negotiation (UP = enabled): Allows
detection of, and adaptation to, full-duplex or half-
duplex mode in device attached to copper link
2nd) Link Pass Through (UP = enabled): Allows a
fault EITHER on the copper OR on the fiber side of the
media converter to stop signal and data transmission
on the other side
3rd) AutoCross™ (UP = enabled): Allows straight-
through twisted pair cable to be used for crossover
connections
4th) Not Used
detection of, and adaptation to, full-duplex or half-
duplex mode in device attached to copper link
2nd) Link Pass Through (UP = enabled): Allows a
fault EITHER on the copper OR on the fiber side of the
media converter to stop signal and data transmission
on the other side
3rd) AutoCross™ (UP = enabled): Allows straight-
through twisted pair cable to be used for crossover
connections
4th) Not Used
Status LEDs
Power: Indicates that DC power is connected
TX (Link Copper): ON indicates TP link; Blinking
indicates TP receive;
FX (Link Fiber): ON indicates fiber link; Blinking
indicates Fiber receive
TX (Link Copper): ON indicates TP link; Blinking
indicates TP receive;
FX (Link Fiber): ON indicates fiber link; Blinking
indicates Fiber receive
Dimensions
Width: 0.86" [22 mm]
Depth: 5.0" [127 mm]
Height: 3.4" [86 mm]
Depth: 5.0" [127 mm]
Height: 3.4" [86 mm]
Power Consumption
2.5 Watts
Environment
See chassis specifications
Shipping Weight
1 lb. [0.45 kg]
Regulatory Compliance
CE Mark, FCC Class A; CISPR Class A; VCCI Class 1
Warranty
Lifetime
Ordering Info [Class A]
CFETF1011-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-FX 1300 nm MM (ST)
[2 km/1.2 mi.] Link Budget: 11.0 dB
CFETF1013-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-FX 1300 nm MM (SC)
[2 km/1.2 mi.] Link Budget: 11.0 dB
CFETF1014-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-FX 1310 nm SM (SC)
[20 km/12.4 mi.] Link Budget: 16.0 dB
CFETF1015-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-FX 1310 nm SM (SC)
[40 km/24.9 mi.] Link Budget: 29.0 dB
CFETF1016-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-FX 1310 nm SM (SC)
[60 km/37.3 mi.] Link Budget: 29.0 dB
CFETF1017-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-FX 1550 nm SM (SC)
[80 km/49.7 mi.] Link Budget: 29.0 dB
CFETF1040-110
100BASE-TX (RJ-45)
[100 m/328 ft.]
to 100BASE-X SFP slot (empty)
Optional Accessories
(sold separately)
(sold separately)
SFP Modules
FCC & CISPR Class A devices comply
with radiated emissions standards
for commercial applications in the
United States (FCC Class A) and Eu-
rope (CISPR Class A).
with radiated emissions standards
for commercial applications in the
United States (FCC Class A) and Eu-
rope (CISPR Class A).
FCC & CISPR Class B devices com-
ply with radiated emissions stan-
dards for residential applications in
the United States (FCC Class B) and
Europe (CISPR Class B).
ply with radiated emissions stan-
dards for residential applications in
the United States (FCC Class B) and
Europe (CISPR Class B).
[See CFETF10xx-205 for
Class B product.]
Class B product.]
Extend Network Distance