Great American Merchandise & Events 4302 Manual De Usuario

1. Probe battery strength
2. Temperature
3.  Temperature Scale
4. Receiver battery strength
5. Signal indicator

 
1. Transmitter button
2. Screen light
3. C°/F° button

1. Battery compartment
2. Wall mount

1. C°/F° button
2. Battery strength indicator
3. Temperature
4. LCD temperature display
5. Transmitter icon
6. Transmitter button
7. Battery cover
8. Transmitter LED indicator 

1. Battery Cover
2. Probe Body
3. Sensor Cover

 

Range of temperature measurement:

Receiver 

 -0 °C to 50 °C (32°F to 122°F)

Remote sensor 

 -50 °C to 70 °C (-58°F to 158°F)

Transmission 

100M (300 ft.) open area, RF 433 MHz

Resolution 

 0.1 degree

Battery life 

3 months (alkaline batteries recommended)

•  Always read the owner’s manual carefully before operating the unit. 

•  Avoid placing the receiver near interference sources/metal frames such as computer 

or TV sets. 

•  The receiver loses its time information when the battery is removed. 

•  The unit will automatically exit all menus after 8 seconds without adjustment. 

•  The remote sensor transmits every 2.5 minutes if the temp change is less than 0.5 °C 

/ 1.1 °F. If the temperature change is more than 0.5 °C / 1.1 °F it will transmit every 30 

seconds. The remote sensor will measure temperature every 10 seconds.

For first time installation, always insert batteries in the receiver unit and then the re-

mote sensor. The receiver will seek a sensor within range.
1- Open the battery cover of the back unit.
2- Install 3 AAA batteries according to polarity indicated.
3- Replace the batteries compartment  cover

•  Screw and install the sensor cover.
•  Place the sensor as close to the receiver as possible.
•  Remove the battery cap.
•  Install three AAA batteries according to polarity indicated.
•  Screw and tighten the battery cap.
•  The red LED on the remote sensor will flash when it transmits a signal. Temperature 

of the remote sensor will be updated and displayed on the sensor’s LCD.

•  Press the “°C/°F” button on the back of the remote sensor to change from Fahrenheit 

to Celsius.

There are two Low battery indication on the receiver and one on the prob. A Low Bat-

tery warning icon will appear on the Probe screen and on the receiver screen. When 

the low battery indicator appears, replace the batteries and follow the setup procedure 

as mentioned in this instruction manual.