Uniden America Corporation UT029 Manual De Usuario

Channels

15 GMRS/7 FRS/7 Weather

Sub Codes

38 Sub-Audible Tones
104 DCS Codes

Operating Frequency

GMRS/FRS:

462.5500 - 467.7125 MHz

WX:

162.4000 - 162.5500 MHz

Power Source

NiMH Battery Pack (BP38) or
4 AAA Alkaline Batteries

Range Channel

1-7 up to 14 miles
(20 miles with Power boost 
button)
Channel 8-14 up to 5 miles
Channel 15-22 up to 14 miles
(20 miles with Power boost 
button)

Battery Life

12 Hours typ. - NiMH
Battery Pack (5/5/90 duty 
cucle)

© 2007 Uniden America Corporation
All rights reserved Printed in China
UTZZ01028ZZ(0)

This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference
received, including interference that may cause
undesired operation.
Important: Changes or modifications to this unit
not expressly approved by Uniden could void your
authority to operate this unit. Your radio is set up 
to transmit a regulated signal on an assigned 
frequency. It is against the law to alter or adjust the
settings inside the radio to exceed those limitations.
Any adjustments to your radio must be made by
qualified technicians.
To be safe and sure:
•  Never open your radio’s case.
•  Never change or replace anything in your radio 

except the batteries.

Your radio might cause TV or radio interference
even when it is operating properly. To determine
whether your radio is causing the interference, turn
it off. If the interference goes away, your radio is
causing it. Try to eliminate the interference by 
moving your radio away from the receiver. If you
cannot eliminate the interference, the FCC requires
that you stop using the radio.
Hazardous Environments: Do not operate the
radio in hazardous environments. Explosion or fire
may result. Do not operate the radio near 
unshielded electrical blasting caps.
Under certain conditions, radios can interfere with
blasting operations and may cause an explosion.
Turn your radio OFF to prevent accidental 
transmission when in a blasting area or in areas
posted: "Turn off two-way radio." Construction
crews often use remote control RF devices to set
off explosives.
Care and Safety: To clean the radio, use a soft
cloth dampened with water. Do not use cleaners or
solvents because they can harm the body of the
unit and leak inside, causing permanent damage.
Use a dry, lint-free cloth to clean the battery 
contacts. Do not submerge the unit in water. If the
unit gets wet, turn it off and remove the batteries
immediately.
Dry the battery compartment with a soft cloth to
minimize potential water damage. Leave the battery
compartment cover off overnight to ensure 
complete drying. Do not use the radio until the unit
is completely dry.

Important: Evidence of original purchase is
required for warranty service.
WARRANTOR: UNIDEN AMERICA 
CORPORATION ("Uniden")
ELEMENTS OF WARRANTY: Uniden warrants, for
one year, to the original retail owner, this Uniden
Product to be free from defects in materials and
craftsmanship with only the limitations or exclusions
set out below.
WARRANTY DURATION: This warranty to the
original user shall terminate and be of no further
effect 12 months after the date of original retail
sale. The warranty is invalid if the Product is:
(A) damaged or not maintained as reasonable or 
necessary, (B) modified, altered, or used as part 
of any conversion kits, sub-assemblies, or any 
configurations not sold by Uniden, (C) improperly
installed, (D) serviced or repaired by someone
other than an authorized Uniden service center for
a defect or malfunction covered by this warranty,
(E) used in any conjunction with equipment or parts
or as part of any system not manufactured by
Uniden, or (F) installed or programmed by anyone
other than as detailed by the owner’s manual for
this product.
STATEMENT OF REMEDY: In the event that the
product does not conform to this warranty at any
time while this warranty is in effect, warrantor will
either, at its option, repair or replace the defective
unit and return it to you without charge for parts,
service, or any other cost (except shipping and
handling) incurred by warrantor or its 
representatives in connection with the performance
of this warranty. Warrantor, at its option, may
replace the unit with a new or refurbished unit.
THE LIMITED WARRANTY SET FORTH ABOVE
IS THE SOLE AND ENTIRE WARRANTY 
PERTAINING TO THE PRODUCT AND IS IN LIEU
OF AND EXCLUDES ALL OTHER WARRANTIES
OF ANY NATURE WHATSOEVER, WHETHER
EXPRESS, IMPLIED OR ARISING BY 
OPERATION OF LAW, INCLUDING, BUT NOT
LIMITED TO ANY IMPLIED WARRANTIES OF
MERCHANTABILITY OR FITNESS FOR A 
PARTICULAR PURPOSE.THIS WARRANTY DOES
NOT COVER OR PROVIDE FOR THE 
REIMBURSEMENT OVERPAYMENT OF 
INCIDENTAL OR CONSEQUENTIAL DAMAGES.
Some states do not allow this exclusion or limitation
of incidental or consequential damages so the
above limitation or exclusion may not apply to you.
LEGAL REMEDIES: This warranty gives you 
specific legal rights, and you may also have other
rights which vary from state to state. This warranty

is void outside the United States of America and
Canada.
PROCEDURE FOR OBTAINING PERFORMANCE
OF WARRANTY: If, after following the instructions
in the owner’s manual you are certain that the
Product is defective, pack the Product carefully
(preferably in its original packaging). Disconnect the
battery from the Product and separately secure the
battery in its own separate packaging within the
shipping carton. The Product should include all
parts and accessories originally packaged with the
Product. Include evidence of original purchase and
a note describing the defect that has caused you to
return it.The Product should be shipped freight 
prepaid, by traceable means, to warrantor at:

WARNING! Read this information before using 
the radio. In August 1996 the Federal
Communications Commission (FCC) of the United
States with its action in Report and Order FCC 
96-326 adopted an updated safety standard for
human exposure to radio frequency 
electromagnetic energy emitted by FCC regulated
transmitters.
Those guidelines are consistent with the safety
standard previously set by both U.S. and 
international standards bodies. The design of the
radio complies with the FCC guidelines and these
international standards.
Never allow children to operate the radio without
adult supervision and the knowledge of the 
following guidelines.
WARNING! It is up to the user to properly operate
this radio transmitter to insure safe operation.
Please adhere to the following:
Use only the supplied or an approved antenna.
Unauthorized antennas, modifications, or 
attachments could impair call quality, damage the
radio, or result in violation of FCC regulations.
Do not use the radio with a damaged antenna.
If a damaged antenna comes into contact with the
skin, a minor burn may result. Please contact your
local dealer for a replacement antenna.
Body-worn Operation
This device was tested for typical body-worn 
operations using the supplied belt-clip.
To maintain compliance with FCC RF exposure
requirements, Body-worn operations are restricted
to the supplied belt-clip.
For hand-held operation, the radio should be held 
1 inch from the user's face. The use of accessories
that do not satisfy these requirements may not
comply with FCC RF exposure requirements and
should be avoided.
For more information about RF exposure, please
visit the FCC web site at www.fcc.gov.

Covered under one or more of the following 
U.S. patents:
4,684,870 4,734,049 5,203,015 5,214,789
5,491,745 5,497,508 5,517,677 5,557,606
5,574,994 5,610,946 5,613,201 5,625,870
5,627,876 5,628,059 5,634,196 5,634,205
5,678,176 5,697,096 5,717,312 5,722,070
5,787,345 5,901,341 6,021,326 6,084,861
6,163,691 6,195,415 6,353,730 6,839,550
6,980,770

Uniden America Service

4700 Amon Carter Blvd. Fort Worth, TX 76155

(800) 297-1023, 7:00 a.m. to 7:00 p.m. CST,

Monday through Friday: 9:00 a.m. to 5:00 p.m. CST,

Saturday, Sunday and Holidays (except

Thanksgiving and Christmas).

transmitted when you press d-call in standard
mode.

To select a call tone:

1) Enter the menu. Advance through the menu until

CALL appears. The current call tone number 
(1-10) flashes.

2) Press 

▲ or ▼ to increase or decrease the

number to the desired call tone. Each tone will
be heard through the speaker.

To transmit the selected call tone, press d-call. The
selected tone is transmitted for a fixed length of
time. Call Tone is cancelled if you press PTT or
Power boost.

Setting Silent Mode
When you turn on the silent mode, all incoming
calls are muted: the radio blinks the display
backlight, the channel indicator, SLNT and call to
alert you to an incoming call. If you do not respond
to the call within 15 seconds, the backlight turns
off, and the call will blink until there is no signal.
The GMR2099 will also vibrate to remind you that
you missed a call. Silent mode is disabled for 15
seconds when you transmit, receive, or press any
other button.

To set the silent mode:

1) Enter the menu. Advance through the menu until

the SLNT appears. The current setting flashes.

2) Press 

▲ to display on SLNT.

Note: To prevent unwanted silent alerts, be sure to
use a Privacy code or group code whenever you
use the Silent mode feature.
You can hear the received voice when you turn on
channel scan and an active channel is detected
even during silent mode.

Missed Call Alerts
If you receive an incoming call while silent mode is
on and do not respond, the radio will turn on the
Missed Call icon. If you are using the Group Mode,
the radio will also indicate the person who made
the call.

The GMR2099 will additionally remind you of a
missed call by vibrating every minute after the call
for 3 minutes.

To lock the keypad:

1) Enter the menu. Advance through the menu until

LOCK appears. The radio displays oF LOCK.

2) To switch Key Lock from oF (OFF) to on (ON),

press

▲.

3) To confirm the setting, press menu/grp. The

radio returns to the current mode.

Note: If you exit the setting mode before confirming
your selection by pressing menu/grp, Key Lock is
set to oF (OFF).

To unlock the keypad:

1) Turn off the radio by rotating vol/off

counterclockwise until it clicks.

2) Turn on the radio again by rotating vol/off

clockwise until it clicks. The keypad is unlocked.

Automatic Power Save Feature
Your GMR2089-2CK/GMR2099-2CK radio has a
unique circuit designed to dramatically extend the
life of the batteries. If there is no transmission nor
an incoming call within 3 seconds, your radio
switches to the Power Save mode. The radio is still
able to receive transmissions in this mode.

LCD Backlight
The LCD Backlight automatically turns on when
any key (except the PTT and Power boost button)
is pressed. The LCD remains lit for 10 seconds
before turning off.

Roger Beep
Roger beep is a beep that is sent to notify the end
of transmission (both PTT and VOX transmission).
You can hear the roger beep can be heard through
the speaker when both roger beep and key beep
are on. When roger beep is on and key beep is off,
you do not hear the roger beep, but it is transmitted
to your party.

To turn the roger beep OFF, press and hold 

▲

while turning ON the radio. Repeat this step to turn
the beep ON.

Your GMR2089-2CK/GMR2099-2CK radio can
receive weather broadcasts from the NOAA
National Weather Service. When in the Weather
Radio Alert mode, the system functions as it does
in standard mode but also monitors the selected
weather channel for alerts when not
communicating. While using the Weather Radio,
you are not able to receive GMRS communications.

1) To turn on the Weather Radio Broadcast mode,

press wx/alert. WX appears.

2) Press ch tone/scn, then press 

▲ or ▼ to

increase or decrease the number to the desired
Weather Channel.

3) To exit the Weather Radio Broadcast mode,

press wx/alert. WX disappears.

• To change the channel continuously, press and

hold

▲ or ▼ for more than 1 second.

• When in the Weather Radio Broadcast mode,

you can only set the Key Lock from the Menu
mode.

Choosing an Emergency/Weather Channel
There are 7 NOAA channel frequencies available
and these frequencies are common between the
US and Canada.You need to know what frequency
is being transmitted in your location.

1) Press and hold wx/alert.

appears.

2) When the unit receives a warning signal, it

beeps for 5 seconds.

, WX and

channel indicator blink.

3) To turn off Weather Alert, press and hold

wx/alert.

disappears.

• When Weather Alert is activated, the highest

priority is given to this function. It checks the
weather alert signals every 7 seconds. When
the unit finds a warning signal, it switches to the
warning receive mode automatically.

• Weather Alert is activated even if key beep is

turned off.

NOAA Weather Radio Frequency List
Channel 1 162.550 MHz Channel 5 162.450 MHz
Channel 2 162.400 MHz Channel 6 162.500 MHz
Channel 3 162.475 MHz Channel 7 162.525 MHz
Channel 4 162.425 MHz

UT028ZH_GMR2089-2CK_E_0110  1/10/07  4:41 PM  Page 2