CalAmp 3640LAB Manual De Usuario

9/27/2017 

LMU-3640 Hardware & Installation Guide - PULS Wiki

https://puls.calamp.com/wiki/LMU-3640_Hardware_%26_Installation_Guide

11/23

 

 

GPS Green 

Comm Orange 

WiFi/BT Blue 

This section details how to quickly get an LMU-3640™ provisioned and configured to point at a specific server. It is assumed that a PEG script has 
already been created and is being managed through LMU Manager or PULS™, the CalAmp Maintenance  System. 

 

We  are making three assumptions to simplify the setup process: 

 

You have created, installed and configured an LM Direct™ Server to receive messages from the LMU-3640™. (See LM Direct™ 
Reference Guide for details) 
You are using the standard wiring harness from CalAmp and the serial port expansion harness. 
You have created a HyperTerminal or Putty session. 
You have contacted the CalAmp sales team regarding the network availability of the LMU-3640™. This device may not be supported 
for all the carriers or networks listed in this section (CDMA-Verizon, CDMA-Sprint, HSPA, GSM), for product availability consult the 
CalAmp sales team. 

 
 

All LMU-3640™s must go through a common step during the configuration and provisioning process. Specifically, this is pointing the LMU to 
your LM Direct™ server, either via IP or a URL. 

This configuration process is accomplished via a series of AT  Commands: 

1. Power up the LMU-3640™ and connect a serial cable from the LMU to your  laptop 
2. Open a terminal session to the  LMU-3640™ 
3. Enter the address of the LM Direct™  server: 

 

 

Where ddd.ddd.ddd.ddd is the publicly addressable IPV4 address of your LM Direct™ server and ppppp is the UDP port  number. 

4. Alternatively if a URL has been set up for your LM Direct™ server, the LMU may be programmed  with: 

 

 

Where myURL.MyCompany.com is the URL assigned to the server. 

5. Enter ATIC to verify the correct settings are displayed for your Inbound  Server. 

 

 

This configuration process is accomplished via a series of SMS Commands: 

1. Power up the LMU-3640™ and your  handset 
2. From the handset, send an SMS message to the LMU-3640™ phone  number: 

 

 

Where ddd.ddd.ddd.ddd is the publicly addressable IPV4 address of your LM Direct™ server and ppppp is the UDP port number 

3. Alternatively if a URL has been set up for your LM Direct™ server, the LMU may be programmed  with: 

 

 

AT$APP PARAM 2319,0,ddd.ddd.ddd.ddd

 

AT$APP PARAM 768,0,ddd.ddd.ddd.ddd 

(32-bit products only) 

AT$APP PARAM 769,0,ppppp

 

 

AT$APP PARAM 2319,0,myURL.MyCompany.Com