Honeywell International Inc. KSN770 Manual De Usuario
Draft
Page 3-116
6 Dec 2012
6 Dec 2012
34-70-06
SYSTEM INSTALLATION MANUAL
066-01204 / 066-01213
© Honeywell International Inc. Do not copy without express permission of Honeywell.
MESSAGE ANNUNCIATE: Will illuminate whenever the message prompt on the KSN 7xx is
ON.
ON.
LP APPROACH ACTIVE ANNUNCIATE: Will illuminate whenever the KSN 7xx is configured
for LP IFR approaches and the unit is in the approach active mode.
for LP IFR approaches and the unit is in the approach active mode.
CDI VLOC ANNUNCIATE: Will illuminate whenever the KSN 7xx is outputting VOR or
LOCALIZER data.
LOCALIZER data.
WAYPOINT ANNUNCIATE: Will illuminate indicating that the aircraft will soon arrive at the
active waypoint. When in the leg navigation mode with turn anticipation enabled, the WPT
annunciator will begin flashing 20 seconds before turn anticipation begins, then will go on
solid when turn anticipation begins, through the conclusion of turn anticipation. When the
KSN 7xx is in the OBS navigation mode or in the leg mode with turn anticipation disabled, the
WPT annunciator will begin flashing 36 seconds prior to the estimated time of arrival at the
active waypoint.
active waypoint. When in the leg navigation mode with turn anticipation enabled, the WPT
annunciator will begin flashing 20 seconds before turn anticipation begins, then will go on
solid when turn anticipation begins, through the conclusion of turn anticipation. When the
KSN 7xx is in the OBS navigation mode or in the leg mode with turn anticipation disabled, the
WPT annunciator will begin flashing 36 seconds prior to the estimated time of arrival at the
active waypoint.
LNAV/VNAV APPROACH ACTIVE ANNUNCIATE: Will illuminate whenever the KSN 7xx is
configured for LNAV/VNAV IFR approaches and is outputting GPS information to the primary
CDI.
configured for LNAV/VNAV IFR approaches and is outputting GPS information to the primary
CDI.
LPV APPROACH ACTIVE ANNUNCIATE: Will illuminate whenever the KSN 7xx is
configured for LPV IFR approaches and is outputting GPS information to the primary CDI.
configured for LPV IFR approaches and is outputting GPS information to the primary CDI.
3.16.3 Requirements and Limitations
A.
Suspend
N/A
B.
Dead Reckoning
N/A
C.
NAV
Requirements for remote switching and annunciation of the KSN 7xx navigation functions vary
depending on the level of certification of the installation. The following requirements represent
typical standards in the USA, but even so may vary regionally within the USA (refer to Table 3-14).
If the switches/annunciators are required, it is required that the message and waypoint alert
annunciators be in the pilot’s primary field of view area (refer to Paragraph 2.3.4.3 Field of View
Considerations). Primary field of view location is highly recommended for the remainder of the
annunciators, but not required. Many EFIS systems provide some amount of switching and
annunciation. A typical EFIS system provides NAV/GPS switching/annunciation and
message/waypoint alert annunciation.
depending on the level of certification of the installation. The following requirements represent
typical standards in the USA, but even so may vary regionally within the USA (refer to Table 3-14).
If the switches/annunciators are required, it is required that the message and waypoint alert
annunciators be in the pilot’s primary field of view area (refer to Paragraph 2.3.4.3 Field of View
Considerations). Primary field of view location is highly recommended for the remainder of the
annunciators, but not required. Many EFIS systems provide some amount of switching and
annunciation. A typical EFIS system provides NAV/GPS switching/annunciation and
message/waypoint alert annunciation.
Draft as of 10/15/2012