Gorko Systems Inc. S1 Manual De Usuario
MiWSN User Manual Rev 1 – Copyright Gorko Systems Inc
11/14
2.11
Status Page
This page displays most recent messages reported by sensors. The Status parameters are
described in the following paragraphs.
described in the following paragraphs.
Name - of the sensor.
Report Time - in Days:Hours:Minutes:Seconds since the sensor sent the message.
Report Type - of message sent by the sensor. Config is sent after successful sensor configure,
Test is sent when the sensor test button is pressed quickly, Reset is sent on very low battery or
replacement, Alarm is sent when an alarm condition is detected, and Report is sent every N
minutes if the Report Period is not zero. Test, Reset, Alarm, and Report messages will cause an
Email to be sent to the Notify Email Address.
Test is sent when the sensor test button is pressed quickly, Reset is sent on very low battery or
replacement, Alarm is sent when an alarm condition is detected, and Report is sent every N
minutes if the Report Period is not zero. Test, Reset, Alarm, and Report messages will cause an
Email to be sent to the Notify Email Address.
Motion - state of Motion sensor. No or Yes.
Temp - current sensor temperature in units specified in the Setup page.
Moisture/Contact - state of sensor Moisture/Contact input. Yes for wet/shorted and No for
dry/open.
dry/open.
Battery - state of sensor battery condition. OK or Low.