Gorko Systems Inc. S1 Manual De Usuario
MiWSN User Manual Rev 1 – Copyright Gorko Systems Inc
7/14
RF Key - a 2 byte hex key used to encrypt RF messages. Only messages encrypted with the
correct key will be processed.
correct key will be processed.
RF Repeat - this will enable the gateway message repeater function. When this is set to “Yes”
the gateway will retransmit valid sensor messages. This retransmission allows the gateway to be
used as a repeater to extend the range of sensor transmissions. When acting as a repeater the
gateway does not need to be plugged into a LAN.
the gateway will retransmit valid sensor messages. This retransmission allows the gateway to be
used as a repeater to extend the range of sensor transmissions. When acting as a repeater the
gateway does not need to be plugged into a LAN.
Temp Units - specifies Fahrenheit or Celsius temperature units.
IP Type - the gateway can use Static or Dynamic IP addressing to join the local network. If
dynamic addressing is used, the gateway gets then next 5 parameters from the local DHCP
server. If static addressing is used, the user specifies the next 5 parameters.
dynamic addressing is used, the gateway gets then next 5 parameters from the local DHCP
server. If static addressing is used, the user specifies the next 5 parameters.
IP Address - of the gateway.
Subnet Mask - of the gateway.
Gateway - IP address the gateway uses for external access.
Primary DNS - IP address gateway uses to resolve Internet names.
Secondary DNS - IP address gateway uses to resolve Internet names.
Enable Emails - Enable sending Emails for messages reported by sensors.
SMTP Server - Name of the outgoing Email server.
SMTP Port - port number.
Use SSL - encrypt email use SSL.
SMTP Account - name for authentication.
SMTP Password - for authentication.
Notify Email Address – to send messages to. Messages are formatted in the subject line of the
Email. Multiple email addresses separated by a coma may be used.
Email. Multiple email addresses separated by a coma may be used.
Save-Reboot – selecting this button will save all Setup parameters and reboot gateway if needed.
Test Email – selecting this button will send a test email to the Notify Email Address to verify
Email parameters are setup correctly. A success or fail message will be displayed after the send
is complete. This can be as quick as less than a second, to about 60 seconds if incorrect
parameters are set. The received email subject will indicate it is from the MiWSN network,
indicate it is a “TestEmail”, and indicate which gateway it came from.
Email parameters are setup correctly. A success or fail message will be displayed after the send
is complete. This can be as quick as less than a second, to about 60 seconds if incorrect
parameters are set. The received email subject will indicate it is from the MiWSN network,
indicate it is a “TestEmail”, and indicate which gateway it came from.