Vertex Standard USA Inc. 11374620 Manual De Usuario

ˆ  To remove the battery, turn the radio off and remove 

any protective cases. Slide the Battery Pack Latch on 
the bottom of the radio toward the front panel while 
sliding the battery down about 1/2 inch (1.5 cm). Then 
lift the battery out from the radio.

ˆ  To install the battery pack, align the battery pack to the 

radio with an offset about 1/2 inch (1.5 cm) from the 
top edge of battery compartment, then slide the battery 
pack upward until it locks in place with a “Click.”

ˆ  Remove the Spacer Plate from the nest of the optional 

CD-58 Desktop Charger, if the Battery Spacer is in-
stalled.

ˆ  Insert the DC plug from the optional PA-55 AC 

Adapter into the DC jack on the rear panel of the op-
tional 

CD-58 Desktop Charger, and then connect the 

PA-55 AC Adapter to the AC line outlet. 

ˆ  Insert the battery pack into the CD-58 Desktop Char-

ger while aligning the slots of the battery pack with the 
guides in the nest of the 

CD-58; refer to the follow-

ing illustration for details on proper positioning of the 
battery pack. If charging with the transceiver attached, 
turn the transceiver off. The antenna jack should be at 

Spacer Plate

AC Line Outlet

Exhibit 8: Operating Manual

FCC ID: AXI11374620

IC: 10239A-11374620

Vertex Standard LMR, Inc.