Bosch Security Systems Inc. M524 Manual De Usuario
Telex TT-16 Transmitter
Page 3
Operating Instructions: When the Power button is pressed, the Channel, Frequency, TX power level,
existing audio level settings and intercom type are displayed. After this point, switch functions as
follows:
Operation
existing audio level settings and intercom type are displayed. After this point, switch functions as
follows:
Operation
Function/Result
Press set
Channel (“blinks”) flashes.
Press up (arrow)
Channel increments.
Press down (arrow)
Channel decrements.
Press set
Flash stops, Channel is set in memory.
Press set
RF Power High flashes
Press up
High power
Press down
Low power
Press set
Flash stops, Level is set in memory. High = displayed, Low = Not displayed
Press set
Unbalanced Audio Level flashes.
Press up
Audio Level increases at 6 dB per step.
Press down
Audio Level decreases at 6 dB per step.
Press set
flash stops, Level is set in memory.
Press set
Input audio type, RTS 1, RTS 2 or Telx will flash, depending on which
source was last selected. Press set again if the flashing
source item is the desired item or Press up/down button
to
select
new
source.
Press set last to save flashing item.
Press set
Balanced Audio Level flashes.
Press up
Audio Level increases at 6 dB per step.
Press down
Audio Level decreases at 6 dB per step.
Press set
flash stops, Level is set in memory.
Press set
Input audio type, RTS 1, RTS 2 or Telx will flash, depending on which
source was last selected. Press set again if the flashing
source item is the desired item or Press up/down button
to
select
new
source.
Press set last to save flashing item.
Special Function Programming:
E.D.R. : If E.D.R. does not already show on the display and Enhanced Audio
Performance is desired, program as follows:
Press the power switch for 2-3 seconds to remove power, if not already off.
Press and Hold the set button and then Press the power button . E.D.R. should
then be displayed near the MHz Icon. To de-select E.D.R., remove power and
re-apply power while holding the set button in.