Cobra Electronics Corporation MRHH425 Manual De Usuario

Programming these features will allow your radio to listen to
all NOAA Hazard Alert radio channels. In this process, you
will be programming the channel settings for the “Specific
Area Message Encoding (SAME)” and “Emergency Alert
Messages” sent by NOAA. See channels and frequencies
listed on page 31.

Start from WX Alert Standby mode to begin WX Alert Setup
programming. Press and hold the Call/Enter/Setup button
for two (2) seconds to enter the programming mode.

1. WX Alert mode is the first mode that begins WX

Alert Setup programming.

2. Display will show WX Alert icon and ON or OFF

flashing.

3. Press Channel Up/Down button to select ON or

OFF.

4. Press Call/Enter/Setup button to save this entry and

move to the next setup programming mode.

1. Display will show WX Alert icon and SCAN, ON or

OFF is flashing.

2. Press Channel Up/Down button to select SCAN, ON

or OFF.

3. Press the Call/Enter/Setup button to save entry.

NOTE
When WX Auto Search (SCAN) is set to On, weather 
channel scanning will start automatically and scan all 
available weather channels until the strongest channel
is found. This will happen under the following 
conditions:

■

WX Alert is engaged.

■

Radio is in VHF Standby.

■

WX received signal level falls below a preset

level.

■

Radio is in Power Saver mode.

MRHH425VP-Body-Eng.qxp:400_Body  10/26/06  1:37 PM  Page 54