Andrew Wireless Innovations Group RPT-MMR8L Manual De Usuario

 

User’s Manual for Remote Unit 

MMR8L L

 

Page 6 

 

M0106ASB.doc 

 

 
1.  Only suitably qualified personnel is allowed to work on this unit and only after 

becoming familiar with all safety notices, installation, operation and maintenance 
procedures contained in this manual. 

 
2.  Read and obey all the warning labels attached to the unit. Make sure that the 

warning labels are kept in a legible condition and replace any missing or 
damaged labels. 

 
3.  Obey all general and regional installation and safety regulations relating to work 

on high voltage installations, as well as regulations covering correct use of tools 
and personal protective equipment. 

 
4.  Keep operating instructions within easy reach and make them available to all 

users. 

 
5.  It is the responsibility of the network provider to implement prevention measures 

to avoid health hazards which may be associated to radiation from the antenna(s) 
connected to the unit. 

 
6.  For US and Canadian installations: To comply with FCC RF exposure compliance 

requirements, the following antenna installation and device operating 
configurations must be satisfied: A separation distance of at least 40 cm must be 
maintained between the antenna of this device and all persons. RF exposure 
compliance may need to be addressed at the time of licensing, as required by the 
responsible FCC Bureau(s), including antenna co-location requirements of 
1.1307(b)(3). Maximum permissible antenna gain, including coaxial cable loss, is 
0 dBi. 

 
7.  Make sure access is restricted to qualified personnel. 
 
8.  Use this equipment only for the purpose specified by the manufacturer. Do not 

carry out any modifications or fit any spare parts which are not sold or 
recommended by the manufacturer. This could cause fires, electric shock or other 
injuries. 

 
9.  Due to power dissipation, the remote unit may reach a very high temperature. 
 
10. Before opening the unit or (dis-)connecting the mains connector at the remote 

unit, ensure that mains supply is disconnected. 

 
11. ESD precautions must be observed! Before commencing maintenance work, use 

the available grounding system to connect ESD protection measures. 

 
12. This unit complies with European standard EN60950.