Clear-Com Intercom Systems Q700BP1 Manual De Usuario

# Attach the two wire whip

antennas to the BNC
connectors on the back panel
of the MS-700 master station.

# Install the power cord and plug

it into the AC source. Turn on
the MS-700 with the front
panel power switch.

# Insert fresh batteries into the

BP-700 bodypacks and turn
them "on" via the power switch
on the main volume control.
The power indicator near this
c o n t rol should illuminate briefly.

# Plug a compatible headset into

each BP-700. 

# Make certain that the operating

frequency ranges of the
MS-700 and BP-700 match. If
there is any question, look at
the frequency labels on the
bottom of the MS -700 and
inside the battery compartment
of the BP-700’s.

# Verify that the frequency

ranges and specific frequencies
programmed into the MS-700
and BP-700’s are those
authorized for the location. If
you are not certain that the
currently-programmed
frequencies are correct, verify
each of them using the
procedure on page 7.

# Move the BP-700 beltpacks at

least 6 feet (2 M) away from
the MS-700 and separate them
from each other by at least 10
inches (40 cm).

# Observe the "RF" LED's on the

receiver section of the front
panel of the MS -700. The LED
corresponding to each active
BP-700 should be illuminated.
If not, recheck that the BP-700
is turned on and that the
frequencies are correct.

# In turn, momentarily depress

the "B" and "C" pushbuttons on
each BP-700. The
corresponding receiver "mode"
LED's on the MS-700 should
illuminate red for pushbutton
"B" and green for "C". 

# Depress the "on" pushbutton on

the front panel of the MS-700

for each active receiver
channel. The adjacent LED
should illuminate to indicate
that the channel is selected. 

# Speak into the headset

microphone for each BP-700
while alternately pressing and
releasing pushbutton "A" on the
unit. You should be able to hear
your voice in the headset
earpiece in one position or the
other. If not, the headset
microphone type may be set
incorrectly. See page 8 for
programming a BP-700 for
dynamic or electret
microphones.

: Whether audio is present

when the pushbutton is pressed
or when it is released depends
upon the programmed
operating mode of the BP-700.
See page 8 for details.

# While speaking into each of the

BP-700 headset mics, select the
corresponding monitor "

MON

"

switch on the MS -700 front
panel. Observe the bar-graph
LED's on the left side of the
MS-700 front panel. The "-2"
LED should illuminate
frequently on voice peaks, but