Clear-Com Intercom Systems Q700MS1 Manual De Usuario

the "+3" LED should illuminate
only rarely.

# If necessary, adjust the

microphone gain for the
BP-700 via the screwdriver
adjustment on the top end of
the unit. This is the adjustment
to the right of the volume
control as viewed from the end
of the BP-700.

# If applicable, connect the wired

intercom system to the rear
panel of the MS-700. Two
intercom channels can be
accommodated at the same
time. For standard Clear-Com
intercom lines, connect line one
to the IC1/IC2 XLR connector,
and line two to the IC2
connector. For "TW" and RTS
systems, both channels are on
the same connector, which
should be plugged into
"IC1/IC2".

# Select "Clear-Com" on the rear

panel (Clear-Com – TW/RTS
pushbutton "in") for standard
Clear-Com lines, or "TW/RTS"
for Clear-Com two-wire or RTS
intercom lines (pushbutton
"out").

# On the MS-700 front panel,

select one or both intercom
channels via the "on"
pushbuttons in the intercom
area on the panel. The
incoming signal can be
monitored by selecting the
appropriate monitor "

MON

"

pushbutton and observing the
bar-graph LED's as described
above.

# Adjust the intercom input and

output levels for the intercom
lines as necessary with the
front panel "in" and "out"
trimmers. If the "null" control
requires adjustment, see
page 11 “Operational Features.”

# If applicable, connect balanced

line-level program audio or IFB
audio to the "PROG" XLR
connector on the MS-700 rear
panel. Monitor and adjust level
with the corresponding controls
on the front panel of the unit.