Clutterfree LLC NRF24 Manual De Usuario
and disables the NRF24L01 module off. The SYNC button on the receive
controller will need to be pressed again in order to enable the NRF24L01.
If the receive unit controller verifies that the data, the controller executes the
“JUMP TO” command by looking at the next byte (RF CHANNEL #) and
determining if it falls within the parameters of its RF channel look up table
determining if it falls within the parameters of its RF channel look up table
located in its non-volatile memory. Once retrieved from its non-volatile
memory, the controller sets the RF Channel of the NRF24L01 RF module to the
RF channel specified by the received data. The receive unit is now operating
memory, the controller sets the RF Channel of the NRF24L01 RF module to the
RF channel specified by the received data. The receive unit is now operating
on the new RF channel and also enables the device identified by the “DEVICE #
indicating the receive unit is ready to accept data from the transmitter unit
over the new RF channel.
Acceptable types of Data:
The WDCS system will only accept specific commands and data as identified by
the
the
Command bytes
above.
FCC Statements:
This module is approved for installation into mobile or/and portable host
platforms and must not be co-located or operating in conjunction with any
other antenna or transmitter except in accordance with FCC multi-transmitter
guidelines.
other antenna or transmitter except in accordance with FCC multi-transmitter
guidelines.
The grant for this device is valid only when the device is sold to OEM
integrators and the OEM integrators are instructed to ensure that the end user
has no manual instructions to remove or install the device.
integrators and the OEM integrators are instructed to ensure that the end user
has no manual instructions to remove or install the device.
End users and installers must be provided with transmitter operating conditions
for satisfying RF Exposure compliance.
for satisfying RF Exposure compliance.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications
not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
user's authority to operate the equipment.
N
OTE
: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.