Sanitag Technologies Corporation AT004H Manual De Usuario
Setting Up Devices & RF Netwowk
1-14
THIS DOCUMENT IS THE PROPERTY OF SANITAG COMPANY. IT MAY NOT BE COPIED AND REPRODUCED WITHOUT WRITTEN PERMISSION OF SANITAG
COMPANY. COPYRIGHT NOTICES MAY NOT BE REMOVED
2.
Connect “Sanitag AC-001-LAN Router” to your Local Network (LAN) via
Hub/Switch.
Hub/Switch.
3.
Plug “Sanitag AC-001-LAN Router” power cable. it creates RF network and blue
led will be on permanently.
led will be on permanently.
4.
Plug Readers’ Power cables one by one. They will try to join RF network which
created previously by Router. The blue led will blink for a while. After finding and
joining to the RF network, the blue led will be on permanently.
created previously by Router. The blue led will blink for a while. After finding and
joining to the RF network, the blue led will be on permanently.
5. If mobile devices are in standby mode, power them up by pressing power button.
You will see led’s power-up indication, and then green led will flash periodically.
The wireless network is ready to operate.
1.3. An Analogy on an Active Instance of the Location Provider
1. Run WipelotServiceManagerHealth.exe file from the Service Manager (Location
Provider Software). After this point, service manager screen will be opened as in
Figure 6.
Figure 6.
Figure 6- Service Manager Screen (Disxonnected Network)
* Figure 6 implies that network is not connected. In the beginning of the same figure, serial port
and connection speed values can be seen.
and connection speed values can be seen.
2. In order to generate a network, room level readers and mobile devices are
activated. Some of them are illustrated in Figure 7, Figure 8, Figure 9.