Shanghai Yuge Information Technology Co. Ltd CLM920 Manual De Usuario

PCM clock 

2048kHz 

PCM Frame synchronization signal 

Short frame 

Data format 

MSB 

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled 

environment .This equipment should be installed and operated with minimum distance 20cm 

between the radiator& your body.   

FCC Label Instructions
The outside of final products that contains this module device must display a label referring to the enclosed 
module. This exterior label can use wording such as: “Contains Transmitter Module
FCC ID:2AN95-CLM920" or “Contains FCC ID:2AN95-CLM920” Any similar wording that expresses the 
same meaning may be used. 

Single Modular Approval. Output power is conducted. This device is to be used in mobile or fixed 

applications only. Antenna gain including cable loss must not exceed 5.41dBi in GSM850,11.41dBi in 

EGPRS850, 2.5dBi in GSM1900, 8.0dBi in EGPRS1900, 10.43dBi in WCDMA Band V, 10.5dBi WCDMA 

Band II, 11.0dBi in LTE Band 2, 7.0dBi in LTE Band 4, 11.42dBi in LTE Band 5,10.50dBi in LTE Band 7 

for the purpose of satisfying the requirements of CFR 47 2.1043 & 2.1091.  The antenna(s) used for this 

transmitter must be installed to provide a separation distance of at least 20 cm from all persons and must 

not be co-located or operated in conjunction with any antenna or transmitter, except in accordance with 

FCC multi-transmitter evaluation procedure. Compliance of this device in all final product configurations is 

the responsibility of the Grantee. Installation of this device into specific final products may require the 

submission of a Class II permissive change application containing data pertinent to RF Exposure, 

spurious emissions, ERP/EIRP, and host/module authentication, or new application if appropriate.