3B TECH Inc COOL-P800 Manual De Usuario
10
RolliBot RolliCool Mini-Split AC User Manual
Before Using the Remote
Pull the tab to remove the protective fi lm.
2.4 – Remote Overview
The RolliCool Mini-Split AC features a remote which may be used with the unit.
REMOTE BUTTONS
Power Button:
Press to turn the unit on or off .
Auto Button:
Press to turn on Auto Mode.
Cool Button:
Press to turn on Cool Mode.
Dehumidify Button:
Press to turn on Dehumidify Mode.
Fan Only Button:
Press to turn on Fan Only Mode.
Schedule Button:
Press to turn on Schedule Mode.
Up Button:
Press to raise temperature or adjust schedule
duration.
Down Button:
Press to lower temperature or adjust schedule
duration.
Fan Speed Button:
Press to cycle between 3 fan speeds.
°C/°F Button:
Press to switch between Celsius and Fahrenheit.
• Avoid pressing two buttons simultaneously as this may cause malfunctions.
• Avoid using the remote in areas with extreme temperature fl uctuations.
• If the remote will not be used for extended periods of time, remove the battery.
• The remote control’s range is approximately 23 ft. Use it within this range.
• The remote uses one CR2 (CR2035 3V) battery. This battery is included.
To Change the Battery
Pull part A in towards the remote then pull
part B out to remove the battery tray. Remove
any dead battery and replace with a new
battery, + side up.
part B out to remove the battery tray. Remove
any dead battery and replace with a new
battery, + side up.
15
RolliBot RolliCool Mini-Split AC User Manual
3.4 – Separating the Coupler
If needed, the Indoor and Outdoor Units can be disconnected from one another in case any
adjustments or maintenance is needed. Before separating the coupler from the unit, turn off the
RolliCool, disconnect it from any power supply and wait at least 5 minutes.
adjustments or maintenance is needed. Before separating the coupler from the unit, turn off the
RolliCool, disconnect it from any power supply and wait at least 5 minutes.
Never separate the coupler while the unit is on.
Step 1.
Unscrew the screw at the right side of the
cover. Push the button at the right side of the
cover and pull it away from the unit to remove
it.
cover. Push the button at the right side of the
cover and pull it away from the unit to remove
it.
Step 2.
Slowly open the latch and hold the Coolant
Lines so that they’re straight. Note, the unit
may emit a chugging sound due to the
refrigerant; this is normal.
Lines so that they’re straight. Note, the unit
may emit a chugging sound due to the
refrigerant; this is normal.
Step 3.
Disconnect the power cable from the inside
of the unit. Lift the Coolant Lines up and away
from the unit to remove it.
of the unit. Lift the Coolant Lines up and away
from the unit to remove it.
Step 4.
Insert the rubber stopper into the end of the
Coupler to prevent leakage.
Coupler to prevent leakage.
Cover
Keep the Coolant
Lines straight
Latch
Power Cable
Rubber Cap
Rollibot-MiniSplitAC-UM-0403.indd Spread 10 of 12 - Pages(10, 15)
Rollibot-MiniSplitAC-UM-0403.indd Spread 10 of 12 - Pages(10, 15)
4/10/2017 7:41:36 PM
4/10/2017 7:41:36 PM