Bortex Industry Co Ltd RGB224LST Manual De Usuario
Made in China
USER SERVICING INSTRUCTIONS:
The sphere lighting is connected with a 24V, 1A adapter. If you want to replace the adapter, it must meet 24V, 1A or
above adapter.
FCC Warning Instruction
Caution:
The user is cautioned that changes or modifications not expressly approved by the
for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital
Part 15 of the FCC Rules. These limits are designed to provide reasonable
interference in a residential installation. This equipment generates, uses
if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
the user is
encouraged to try to correct the interference by one or more of
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
the following measures:
This transmitter must not be co-located or operating in conjunction with any other antenna
party responsible
device, pursuant
to
protection against harmful
and can radiate radio frequency energy and,
However, there is no
equipment off and on,
environment.
or transmitter.
The postion of ferrites are 2cm from the adapter and 10cm from the controller , can't be removed casually ， otherwise will
be conducted emission fail