Iotek Systems LLC HXC900 Manual De Usuario
HXC Client Module User Guide
Version 1.09
© 2017 All rights reserved. Iotek Systems, LLC
Page 57 of 59
13 Appendix V: FCC and IC Compliance
The below statements are applicable for HXC Client Module 900Mhz (Model: HXC900).
13.1 Federal Communication Commission (FCC)
13.1.1 Compliance Statement (Part 15.19)
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1. This device may not cause harmful interference, and
2.
This device must accept any interference received, including interference that may
cause undesired operation.
13.1.2 Warning (Part 15.21)
Changes or modifications not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
13.1.3 FCC Interference Statement (Part 15.105 (b))
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
To comply with FCC/IC RF exposure limits for general population/uncontrolled exposure
during indoor application, the antenna(s) used for this transmitter must be installed to
provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
provide a separation distance of at least 20 cm from all persons and must not be co-
located or operating in conjunction with any other antenna or transmitter.
To comply with FCC/IC RF exposure limits for general population/uncontrolled exposure
during outdoor application, the antenna(s) used for this transmitter must be installed on
outdoor permanent structures to provide a separation distance of at least 20 cm from all
persons and must not be co-located or operating in conjunction with any other antenna
persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.