WINLITE INTERNATIONAL LTD SH2000 Manual De Usuario

1. Press and hold the power/phone button for at least 7 seconds to turn the headset on. You will

hear a voice say “Power on”, then continue to hold the button until you hear “Ready for pairing”
and the LED power indicator light will rapidly flash blue and red.

NOTE: During the first time set-up, you must hold the power/phone button down until you hear a
voice say “Ready for pairing” in order to sync your device to Bluetooth. After the initial pairing, you
can let go of the power/phone button after you hear “Power on”.

2.  Open the settings on your Bluetooth device. (Bluetooth must be enabled)
3.  Select “SH2000” from the list of Bluetooth devices.
4.  Once paired, you will hear a beep then a voice say “Device connected”. The LED power indicator

light will blink blue.

5. To turn off the SH2000, press and hold the power/phone button for at least 7 seconds. You will

hear a voice say “Power off” before the headset turns off.

NOTES:



Your device will automatically find and pair with the SH2000 Sport Headset after the initial
pairing. If your device does not automatically pair, the SH2000 will say “Pairing not
completed”. Turn off the headset and repeat steps 1-4.



The SH2000 will automatically pair to the last device connected.



The volume up/down buttons on the SH2000 may control the volume on your device.
Device’s results may vary.

Troubleshooting
Issue: My SH2000 doesn’t turn on.
Solution: Try the following:

•  Make sure the SH2000 is charged.
•  Make sure the volume is turned up on your device and the SH2000.
•  Make sure you press and hold the power/phone button for at least 7 seconds.

Issue: My SH2000 is not charging.
Solution: Try the following:



Make sure that the charge port on the headset is free from dust and debris.



Make sure that you are using the charge cable that came with your SH2000.



Make sure there is power coming from the power source.

Issue: My SH2000 isn’t syncing to Bluetooth.
Solution: Try the following:

• Make sure you hold the power/phone button down until you hear a voice say “Ready for

pairing” after it says “Power on”.

•  Make sure that the Bluetooth setting is turned “ON” on your device.
•  Check to see if another user is connected to the SH2000.
•  Refer to the user guide of your device for Bluetooth syncing instructions.

Issue: My SH2000 volume is turned all the way up, but the volume is still very low.