Bose Corporation 416317 Manual De Usuario

 Preparing the Headset for Use

Your headset may be shipped with the microphone assembly (boom microphone 

and cable) attached to the left earcup. If you prefer, you can switch it to the right 

earcup. 

If your headset is shipped with the microphone assembly packed separately, you 

can attach it to either earcup.

Choose the earcup (L or R) where you want to attach the microphone assembly. 

Also, make sure that the earcup connector pins are clean and free of debris.
1.  Use a Phillips screwdriver to loosen the two screws on the terminator cover 

near the bottom of the earcup where you want to attach the microphone 

 assembly. 

2.  Remove the terminator cover to reveal the connector pins on the earcup.
3.  Carefully line up the microphone assembly to the small connector socket on 

the earcup.

4.  Slide the connector into the socket until it reaches the stop.

Terminator 

cover

Connector 

pins

Microphone 

assembly

Connector pins

L (left)

Caution:   Do not force the connector into the socket, or earcup damage may  

occur.

5.  Tighten the screws to secure the assembly.
6.  Attach the terminator cover to the earcup that does not have the microphone 

assembly attached. Insert the screws, then align and tighten them.
Note: The headset will not work without the terminator cover installed.
Caution: Be sure to try the headset and fully test its operation before flight.