Motorola Solutions Inc. 99FT4100 Manual De Usuario

The Bottom Panel interface provides the electrical interconnection interface between the SLR 1000
Repeater and the end user’s system. This includes the connectors necessary to program/configure the
repeater, as well as interface the repeater to the power system, system controllers, LANs, and other
communications and maintenance equipment. This section provides a general description,
identification of inputs/ outputs and how the inputs are connected and sealed, and a pin-out listing for
all connectors, including information on signal names, functions, and levels.

Figure 12: SLR 1000 Repeater Bottom Panel Connector Names and Locations on page 53

 shows

the various interface connector locations. 

Table 14: SLR 1000 Repeater Connector Types and Primary

Functions on page 53

 lists the connector types as well as its primary function.

Table 14: SLR 1000 Repeater Connector Types and Primary Functions

1

N-Type – Fe-
male

Transmitter RF (Tx)

2

M6 TORX Screw

Bonding Ground Connection

3

2.1 X 5.5 OD
Barrel Connector

DC Power Inlet

4

RJ-45 – Aux/
Accessory

Rx Audio, Tx Audio, PTT, 1 PPS, and GPIO

5

RJ-45 – Ethernet

Network

6

Type B USB
Socket

Programming Interface

7

Option Depend-
ent

Option Dependent 1 and 2

8

N-Type – Fe-
male

Receiver RF (Rx)

This section describes the different bottom panel interfaces that are available in the repeater.

MN003557A01-AA

SLR 1000 Bottom Panel

Send Feedback

  53