Arris HDUDTAP2 Manual De Usuario
Setting Up Your HD-DTA100u and
RF4CE Remote Control
IMPORTANT! Read the enclosed Safety Instructions before you begin.
1. Connect your cable service.
Connect the coaxial cable from your wall outlet to the Cable In port on the
HD-DTA100u.
Connect the coaxial cable from your wall outlet to the Cable In port on the
HD-DTA100u.
2. Connect your TV.
If you have a high-definition TV, use the HDMI connector.
If you have a standard-definition TV, use the To TV connector.
If you have a high-definition TV, use the HDMI connector.
If you have a standard-definition TV, use the To TV connector.
3. Plug in the HD-DTA100u.
Connect the power cord to the HD-DTA100u, then plug it into an unswitched
electrical outlet.
Connect the power cord to the HD-DTA100u, then plug it into an unswitched
electrical outlet.
4. Turn on the TV and select the input.
If you have an HDTV, use the remote control for your TV to select the HDMI port
you used to connect the HD-DTA100u.
If you have an SDTV, tune your TV to Channel 3 and set the switch on the back
of the HD-DTA100u to CH 3. If your screen remains black, switch your TV and
HD-DTA100u to CH 4.
If you have an HDTV, use the remote control for your TV to select the HDMI port
you used to connect the HD-DTA100u.
If you have an SDTV, tune your TV to Channel 3 and set the switch on the back
of the HD-DTA100u to CH 3. If your screen remains black, switch your TV and
HD-DTA100u to CH 4.
5. Put the batteries in the HD-DTA100u remote control.
6. Program the RF4CE remote control.
Point the remote control at the HD-DTA100u. Press and hold the SETUP button
until the LED on the remote control blinks twice, then press the Menu button.
The LED will blink continuously until the remote control is paired. Follow the
pairing instructions on the screen. (Pairing instructions are also printed on the
back of the remote control.)
Point the remote control at the HD-DTA100u. Press and hold the SETUP button
until the LED on the remote control blinks twice, then press the Menu button.
The LED will blink continuously until the remote control is paired. Follow the
pairing instructions on the screen. (Pairing instructions are also printed on the
back of the remote control.)