Furuno USA Inc 9ZWRTR115 Manual De Usuario
1. INSTALLATION
4
• Deposits and fumes from a funnel or other exhaust vent can adversely affect the
aerial performance and hot gases may distort the radiator portion. The radar sen-
sor must not be mounted where the temperature is more than 55°C (131°F).
sor must not be mounted where the temperature is more than 55°C (131°F).
1.3
Installation of the Radar Sensor
Determine the suitability of the mounting location BEFORE permanently mounting the
sensor. Incoming and outgoing signals may overlap one another depending on the
shape of the vessel, preventing communication between the radar and display. Set the
sensor on the selected location and connect the sensor to the distribution switchboard
and display unit. Turn on the sensor and the display unit. Check that the picture is up-
dated with each sweep on the display unit. Some trial and error may be necessary to
find a suitable location.
sensor. Incoming and outgoing signals may overlap one another depending on the
shape of the vessel, preventing communication between the radar and display. Set the
sensor on the selected location and connect the sensor to the distribution switchboard
and display unit. Turn on the sensor and the display unit. Check that the picture is up-
dated with each sweep on the display unit. Some trial and error may be necessary to
find a suitable location.
Required tools for installation
Prepare the tools shown below.
• A wrench for M10 bolts
• An electric drill with
• An electric drill with
11 mm (0.43”) drill bit
Installation on a platform
There are 6 steps to proceed for installing the radar sensor to the selected location.
Below illustration shows the collective information explained from steps 1 to 6.
Below illustration shows the collective information explained from steps 1 to 6.
STERN
BOW
Align bow mark (Δ) on
radome with ship’s bow.
Align bow mark (Δ) on
radome with ship’s bow.
Power/LAN cable (1 m)
Holes drilled referring to the outline drawing
and the mounting template in this manual.
and the mounting template in this manual.
Platform
Hex bolt (M10×20)
Spring washer
Flat washer