General Research of Electronics Inc 0705 Manual De Usuario

0705 Owner’s Manual

2. Install the DIN sleeve into the opening in your dashboard, lip facing out.

3. Push out the top and bottom tabs to hold the sleeve firmly in place.

4. Slide the scanner into the sleeve until it locks in place.

To remove your scanner from the DIN sleeve, insert the two keys straight into the scanner’s front panel.

Then remove the scanner by pulling front panel.

When mounting in your dashboard, you will need to connect an external antenna and an external speaker.

Mobile Mounting in Your Vehicle

You can mount your scanner under the dashboard, or on top of it, using the mounting bracket.

1. Attach the three protective rubber feet to the mounting bracket when you use the scanner on a flat

surface. Do not use them when you mount the bracket with screws.

2. Use the supplied mounting bracket as a template to mark positions for the two mounting screws.

3. At the marked positions, drill holes slightly smaller than the screws.

4. Remove the paper backing from each washer and stick one inside of each bracket’s ear, aligning the

washer’s hole with the bracket’s hole.

5. Attach the mounting bracket to your vehicle’s surface using the supplied screws and lockwashers.

6. Slide the scanner into the bracket, aligning the scanner’s holes with the holes in the bracket, and then

screw the mounting knobs into the scanner.

When drilling holes, be sure to avoid obstructions behind the mounting surface. Consult a qualified

installer if in doubt.

Using Your Scanner as a Base Station

You can place your scanner on a desk, shelf, or table to use it as a base station. Since the speaker is on

the bottom of the scanner, you may want to use the mounting bracket to elevate your scanner off the

surface for better sound. Follow the mobile vehicle mounting instructions above to affix your scanner to a

desk, shelf, table or other flat surface (except that the bracket will be below the scanner).

Page 3