General Research of Electronics Inc 0711 Manual De Usuario
0711 Owner’s Manual
LIGHT, VOLUME, and SQUELCH.
Note: The keylock does not prevent the scanner from scanning channels or monitoring a
single channel, whichever feature you last selected.
To turn on the keylock, hold down (Key Symbol) for about 3 seconds until the scanner beeps
three times and (Key Symbol) appears. To turn it off, hold down (Key Symbol) for about 3
seconds until the scanner beeps three times and (Key Symbol) disappears.
Cloning the Programmed Data
You can transfer the programmed data to and from another 0711 scanner using an optional
connecting cable with 3.5mm phone plugs on both ends (not supplied).
1. Turn on both scanner.
2. Connect the connecting cable to each scanner’s PC/IF jack. CLOnE and UP to SEnd
appears.
3. Press ^ at the host scanner.
4. SEndInG appears at the host scanner.
The scanner sends the data. To exit the clone mode, remove the cable.
CLOnE and Error may alternately appear when the scanner receives data from a scanner
other than a 0711. If this happens when the scanner receives data from another 0711, turn
off the scanner and then turn it on again.
INITIALIZING THE SCANNER
If the scanner’s display locks up or does not work properly after you connect a power source,
you might need to initialize the scanner.
Important: This procedure clears all information you stored in the scanner’s memory.
Page 32