General Research of Electronics Inc 0712 Manual De Usuario

0712 Owner’s Manual 

 

3. Press ^ at the host scanner. 

 

4. SEndInG appears at the host scanner. 

 

The scanner sends the data. To exit the clone mode, remove the cable. 

 

CLOnE and Error may alternately appear when the scanner receives data from a scanner other than a 

0712. If this happens when the scanner receives data from another 0712, turn off the scanner and then 

turn it on again. 

 

 

INITIALIZING THE SCANNER 
 

If the scanner’s display locks up or does not work properly after you connect a power source, you might 

need to initialize the scanner. 

 

Important: This procedure clears all information you stored in the scanner’s memory. Initialize the 

scanner only when you are sure the scanner is not working properly. 

 

1. Turn off the scanner, then turn it on again. WELCOME SCAnnInG rECEIVEr appears. 

 

2. Press 0 while welcome message appears. Then press 1. InItIAL appears about 2 seconds. After 2 

seconds, YES ---Ent and No ---CLEAr appears alternately. 

 

3. Press ENT. WAIt appears for about 2 seconds. 

 

Note: Do not turn off the scanner until the initialization is complete. When the initialization is complete, 

1CH 000.0000 appears on the display. 

 

A GENERAL GUIDE TO SCANNING 

 

Birdie Frequencies 

 

Every scanner has birdie frequencies. Birdies are signals created inside the scanner’s receiver. These 

operating frequencies might interfere with transmissions on the same frequencies. If you program one 

of these frequencies, you hear only noise on that frequency. If the interference is not severe, you might 

be able to turn SQUELCH clockwise to cut out the birdie. 

 

Page 26