ICOM 263300 Manual De Usuario

24

4

REPEATER OPERATION

New2001

■ Offset frequency

[

When communicating through a repeater, the transmit fre-
quency is shifted from the receive frequency by an amount
determined by the offset frequency. 
Independent offset frequencies can be set for each operating
frequency.

q Push [BAND] to select the desired frequency band.
w Select the desired mode/channel you wish to set the offset

frequency to, such as VFO mode or memory/call channel.

• The offset frequency can be independently programmed into

each mode or channel.

e Push [SET•LOCK] to enter set mode.
r Push [SET•LOCK] or [S.MW•MW] until “DUP” and offset

frequency appear.

t Rotate [DIAL] to set the desired offset frequency.
y Push [V/MHz•SCAN] to exit set mode.

z Push [BAND] to select the desired frequency

band.

• Enter the desired frequency via the keypad if neces-

sary.

x Select the desired mode/channel you wish to

set the offset frequency to, such as VFO mode
or memory/call channel.

• The offset frequency can be independently pro-

grammed into each mode or channel.

c Push [

SET

B(D-OFF)] to enter set mode.

v Push [

SET

B(D-OFF)] or [

ENT

C(T-OFF)] until

“DUP” and offset frequency appear.

b Push [Y] or [Z] to set the desired offset.

• Direct frequency entry from the keypad is not possi-

ble.

n Push [

CLR

A(MW)] to exit set mode.

☞NOTE: The offset frequency can be set in a memory/call

channel temporarily. However, the set frequency is cleared
once another memory channel or VFO mode is selected.
To store the offset frequency permanently, overwrite the
channel information.

Push         

SET

B

[SET•LOCK]

“DUP” and offset frequency appear

IC-208H.qxd  03.2.26 20:00  Page 24 (1,1)