ICOM 269800 Manual De Usuario
23
4
REPEATER OPERATION
■ Auto repeater
(U.S.A. version only)
The USA and CSA versions automatically activate the re-
peater settings
peater settings
(DUP– or DUP+ and tone encoder ON/OFF)
when
the operating frequency falls within the general repeater out-
put frequency range and deactivate them when outside of the
range.
put frequency range and deactivate them when outside of the
range.
D Setting the auto repeater function ON/OFF
q Push [PWR] to turn power OFF.
w While pushing [SET
w While pushing [SET
], turn power ON to enter initial
set mode.
e Push [SET
] several times until the “RPT” display
appears as shown above right.
r Rotate [DIAL] to turn the auto repeater function to “R1,”
“R2” or OFF.
• “R1”: auto repeater is ON, tone encoder is OFF.
• “R2”: auto repeater is ON, tone encoder is ON.
t Push [PWR] to exit initial set mode.
D Frequency range and offset direction
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
NAR
MID
LOW
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
NAR
MID
LOW
Auto repeater function is
turned OFF.
turned OFF.
Auto repeater function is ON,
tone encoder is ON.
tone encoder is ON.
LOCK
[PWR]
[SET
LOCK
]
LOCK
USING
INITIAL SET MODE
Frequency range
Duplex direction
145.200–145.495 MHz
“–” appears
146.610–146.995 MHz
147.000–147.395 MHz
“+” appears