ICOM 272103 Manual De Usuario

19

4

BIIS OPERATION

D Direct code entry

q

  While in the standby condition, push [P3] (TX Code Enter) 

to enter the TX code edit mode.

  • Editable code digit blinks.

w

  Push [P3] (TX Code Enter) to select the desired digit to 

be edited.

  • Editable digit differs according to the setting.

e

  Set the desired digit using [CH Up]/[CH Down]/[TX Code 

CH Up]/[TX Code CH Down] or 10-keypad.*

  *Depending on version

r

  Push [P3] (TX Code Enter) to set the digit, then the edit-

able digit will move to the right automatically.

  •  When the 10-keypad is used to set, the editable digit will move 

to the right automatically without pushing [P3] (TX Code Enter).

t

  Repeat e and r to input all allowable digits.

y

  Push [P0] (Call) or [PTT]* to call.

  * PTT call can be made only when PTT call capability is permitted.

 

 

NOTE: When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically, 
and “

”

 is displayed during each call. However, an 

error beep sounds and “

”

 is displayed when no 

answer back is received after the calls.

u

 Push [PTT] to transmit; release to receive.

i

  Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’ 

signal.

For your information 
When the “UpDate” setting for the call code is enabled, the 
set code is overwritten into the call code memory.