ICOM 272103 Manual De Usuario
24
4
BIIS OPERATION
D Programming an SDM memory
(10-keypad version is required)
q
During standby condition, push [P1] (Digital) twice, then
push [UP] or [DOWN] to select the desired SDM to be
edited.
edited.
w
Push [M] or [#] to enter the message editing condition.
• The first character blinks when [#] is pushed, the last character
blinks when [
M
] is pushed as below.
e
Push the appropriate digit key, [0] to [9], to enter the
desired character.
• See the table at right for the available characters.
• Pushing [UP] also enters space, pushing [DOWN] deletes the
• Pushing [UP] also enters space, pushing [DOWN] deletes the
selected character.
r
Push [#] to move the cursor to the right, push [M] to move
the cursor to the left.
t
Repeat steps e and r to set the desired text message.
y
Push [P1] (Digital) for 1 sec. to overwrite the set content
into the memory.
• Push [P1] (Digital) momentarily to cancel the editing and return
to the original message indication.
• Available characters
NOTE: Once the pre-programmed character including a
decimal point is rewrote with the 10-keypad, the decimal
point cannot be displayed again.
decimal point is rewrote with the 10-keypad, the decimal
point cannot be displayed again.
Key
[0]
[1]
[2]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
[3]
[4]
[5]
[6]
[7]
[8]
[9]
Characters
(0)
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(.)
(Space)
(A)
(D)
(D)
(G)
(J)
(M)
(P)
(T)
(T)
(W)
(!)
(#)
(B)
(E)
(H)
(K)
(N)
(E)
(H)
(K)
(N)
(Q)
(U)
(U)
(X)
(?)
(�)
(C)
(F)
(I)
(L)
(O)
(R)
(R)
(V)
(Y)
(Y)
(')
(/)
(a)
(d)
(g)
(d)
(g)
(j)
(m)
(S)
(t)
(Z)
(")
(+)
(b)
(e)
(h)
(k)
(n)
(p)
(u)
(e)
(h)
(k)
(n)
(p)
(u)
(w)
(,)
(Ð)
(c)
(f)
(i)
(l)
(i)
(l)
(o)
(q)
(v)
(x)
(q)
(v)
(x)
(;)
(=)
(r)
(y)
(:)
(_)
(()
())
(<)
(>)
([)
(])
(/)
(&)
(%)
($)
(@)
(^)
(s)
(z)