ICOM 325300 Manual De Usuario

N Full/band/programmed scan 

qPush [V/M/C]

 to select the VFO mode

.

• Select a desired frequency band with [BAND], if desired.

wSet the squelch level.

e  Push and hold [SCAN](H/M/L) for 1 sec. to enter the scan-

ning type selection.

r  Rotate [DIAL] to select a desired scanning type.

• “ALL” for full scan; “bAnd” for band scan, “P-LInk x” for pro-

grammed link scan (x= 0 to 9), “PROG

xx

 (or scan name if pro-

grammed)” for programmed scan (

xx

= 0 to 24; only programmed 

scan edge numbers are displayed), “dUP” (appears only when 
duplex operation is set) for duplex scan.

[DIAL]

Full scan

Band scan

Duplex scan

Programmed link scan

Push and hold
for 1 sec.

Programmed scan

Rotate

Selectable from “0” to “9.”

Selectable from “0” to “24,”
if programmed.

tPush [SCAN](H/M/L) to start the scan.

• Scan pauses when a signal is received.
• Rotate  [DIAL] to change the scanning direction. This also 

causes the transceiver to resume scanning.

• Push [V/M/C] to stop the scan.
• Push [BAND] to change the band during band scan, or change 

the scan edge during programmed scan/program link scan.

During full/band scan

During programmed scan

Scan name can be displayed instead of “P-LInk x” for pro-
gram link scan (x= 0 to 9), “PROGxx” for programmed scan 
(xx= 0 to 24) when scan name is programmed and set to ON 
in the Initial set mode.

Scan name is not displayed during scan.

42

7

SCAN OPERATION