Rigado Inc. 04 Manual De Usuario
BMD-300 Series Module Datasheet
Bluetooth 4.2 LE
03/23/2016
BMD-300-DS-V0.9.4
Page 20 of 25
15.5 CE Regulatory:
This device will be tested and compliant against the following standards. OEM integrators should consult with
qualified test house to verify all regulatory requirements have been met for their complete device.
From Directive 2006/95/EC:
qualified test house to verify all regulatory requirements have been met for their complete device.
From Directive 2006/95/EC:
EN 60950-1: 2006 + A11: 2009 + A1: 2010 + A12: 2011
From R&TTE Directive 1999/5/EC:
ETSI EN 300 328 V 1.8.1
From Directive 2004/108/EC:
ETSI EN 301 489-1 V1.9.2
EN 61000-3-2: 2014, EN 61000-3-3:2013
ETSI EN 301 489-17 V2.2.1
Declarations of Conformity and supporting test reports are available at
15.6 Japan (MIC)
The BMD-300 Series modules have received type certification and is labeled with its own technical conformity
mark and certification number as required to conform to the technical standards regulated by the Ministry of
Internal Affairs and Communications (MIC) of Japan pursuant to the Radio Act of Japan. Integration of this
module into a final end product does not require additional radio certification provided installation
instructions are followed and no modifications of the module are allowed. Additional testing may be required:
mark and certification number as required to conform to the technical standards regulated by the Ministry of
Internal Affairs and Communications (MIC) of Japan pursuant to the Radio Act of Japan. Integration of this
module into a final end product does not require additional radio certification provided installation
instructions are followed and no modifications of the module are allowed. Additional testing may be required:
• If the host product is subject to electrical appliance safety (for example, powered from an AC mains),
the host product may require Product Safety Electrical Appliance and Material (PSE) testing. The
integrator should contact their conformance laboratory to determine if this testing is required.
integrator should contact their conformance laboratory to determine if this testing is required.
• There is a voluntary Electromagnetic Compatibility (EMC) test for the host product administered by
VCCI:
The label on the final end product which contains a BMD-300 Series module must follow the MIC marking
requirements. Labeling requirements for Japan available at the Ministry of Internal Affairs and
Communications (MIC) website:
The BMD-300 module is labeled with its assigned technical conformity mark and certification number. The
final end product in which this module is being used must have an external label referring to the type certified
module inside: