Circuitlink Pty Ltd TACHO5B Manual De Usuario
Circuitlink Pty Ltd, ABN 80 057 670 505, 7/30 Foundry Road, Seven Hills NSW 2147 Australia T: +61 2 9624 1922 F: +61 2 9624 1911
E: support@circuitlink.com.au Document Status: Final. Publish Date: 9/02/2015
CIRCUITLINK.COM.AU
16
Connecting the T5
Caution
-
The vehicle should be turned off when disconnecting any connectors on the T5
-
Ensure when inserting the Samtec connector it is plugged in straight to avoid damaging the
fine pitched pins within the connector.
fine pitched pins within the connector.
Warning
Only use cable assemblies described in this guide. Using assemblies for other models may damage the unit
and other equipment on the vehicle.
and other equipment on the vehicle.
1.
Attach and firmly tighten the SMA connectors for the GPS, GSM and WIFI antennas.
When antennas are not in use it is recommended to keep the antenna attached or use (PN 3400139 - SMA plug cap)
to protect the connector from dust and water.
When antennas are not in use it is recommended to keep the antenna attached or use (PN 3400139 - SMA plug cap)
to protect the connector from dust and water.
2.
With power to the unit disconnected, connect the I/O cables from the unit to the vehicle.
Removing the Face Plate
For any reason you are required to remove the T5 from its housing either to change SIM cards or as directed by
Circuitlink, you must follow these steps. For best results, use PN 5991111611 available from Cinch.
Circuitlink, you must follow these steps. For best results, use PN 5991111611 available from Cinch.
1. With power to the unit disconnected, remove the I/O and antenna cables from the T5.
2. If possible, remove the T5 from where it is mounted as you need access to all sides.
3. With a small flat blade screw driver, gently release the one of the side tabs and let it balance without re-seating.
2. If possible, remove the T5 from where it is mounted as you need access to all sides.
3. With a small flat blade screw driver, gently release the one of the side tabs and let it balance without re-seating.
Starting from the top of the case, prise each of the tabs along the top, then along the bottom to release the face
plate.
plate.
4. Finally release the last side tab and gently slide the unit from the case.
5. When re-inserting the unit, make sure there are no internal wires caught and gently press the face plate back into
5. When re-inserting the unit, make sure there are no internal wires caught and gently press the face plate back into
the housing making sure not to damage the rubber sealing gasket until all the tabs click into place.
Warning
Do not place the PCB on any conductive or wet surfaces.
Where possible, follow steps to protect against ESD damage.
Improper removal of the face plate will compromise its IP rating and reliability of the device
Where possible, follow steps to protect against ESD damage.
Improper removal of the face plate will compromise its IP rating and reliability of the device