Barco N.V. WHE10016 Manual De Usuario
11
7.4 Network Setup
1) Click on “Network Setup” option, it will show the network setting items
.
< IP Setup>
You can select “obtain IP address automatically” or “Use the following IP
address” to manually enter the IP address.
The default setting is as follows:
IP Address: 192.168.100.10.
Subnet Mask: 255.255.255.0
Default Gateway: 192.168.100.10
DNS Server: 192.168.100.10
7.5 WiFi Setup
Wireless LAN: The default setting is “Enable”
Connect to Existing AP: Press the “Scan” button to scan all available AP
devices, and then select the WiFi AP that you want to connect to.
Encryption: Select “Disable” or one of WEP/WPA PSK/WPA2 PSK
Key: If Encryption is enabled, you have to enter a key according to the
encryption mode you selected. (If the length of the key entered is not
sufficient or too long, a warning message will appear.)
Note: The Encryption and Key information must be consistent to the exiting
AP configuration.
devices, and then select the WiFi AP that you want to connect to.
Encryption: Select “Disable” or one of WEP/WPA PSK/WPA2 PSK
Key: If Encryption is enabled, you have to enter a key according to the
encryption mode you selected. (If the length of the key entered is not
sufficient or too long, a warning message will appear.)
Note: The Encryption and Key information must be consistent to the exiting
AP configuration.