Shenzhen Zowee Technology Co. Ltd. M234AA Manual De Usuario

LED Stays Red: Waiting for Wi-Fi setup or Wi-Fi setup failed

LED blinks Red slowly: Start to configure network

LED blinks Blue: Start to connect to network

LED Stays Blue: Wi-Fi setup successfully or Ring Button 

pushed by a guest

Charge your device using a USB-compatible charger, to 

ensure your device is fully charged. Charge the device 

prior to Wi-Fi setup and installation.

Before hardware installation, connecting the device to 

your home Wi-Fi network (The device Support 2.4GHz Wi-Fi 

currently). 

And please ensure that your mobile phone is connected to 

your home Wi-Fi network before setup.

1. Download and install the Video Doorbell app from App

store or Google play by searching ‘Danale’

2. Launch the ‘Danale’ app and log in with your Danale+ 

account. If it’s the first time of using Danale+, please sign up 

and create your own account.

3. Power on the device by  a USB-Compliance charger,

and press the Reset button on the back of the device to 

start connecting.

4. Click on Add Device on the app, then search the device 

or scan QR Code to finish Wi-Fi setup.

1. Remove your current doorbell button and power off your 

transformer (for wired installation only)

2. Install the mounting bracket using the provided

screwdriver bit, handle and drill bit

3. Connect your doorbell wiring to the terminal screws

located on the mounting bracket (For wired installation 

only)

4. Place the device on the mounting bracket

5. Tighten the security screws at the bottom of the device

using the proprietary screwdriver bit. Please do not 

over-tighten the security screws.

6. Provide power back to your transformer (For wired

installation only)

  

If your chime is electronic, you may need to install a diode, 

which is commonly found inside your current doorbell 

button, or check with your doorbell manufacturer.

Connect the diode to the terminals with the arrow on the 

diode facing towards the doorbell inside chime as show 

below 

1

2

3

5

4

6

7

8

9

AC

IN

Rear

Transformer

Front

P1-With Doorbell 

Chime(VAC)

Connector

Connector

Secondary Power=

10-36 VAC 10VA

Wired,Mechanical

Doorbell Chime

Low Voltage Transfomer

Primary Power

US=120/130 VAC

UK&EU=220/230/240 VAC

1

X

1

X

1

X

1

X

1

X

4

X

4

X

2

X

2

X

Mounting Bracket

slip into the hooks

120*80-1

05g哑粉纸-彩色印
刷-风琴折

DB3518E-234AA-ZW 

234AA

120*80-105g

Any Changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment. 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must accept any 

interference received, including interference that may cause undesired operation.     

This  equipment  complies  with  FCC  radiation  exposure  limits  set  forth  for  an uncontrolled 

environment.  This  equipment  should  be  installed  and  operated  with  minimum  distance  20cm 

between  the  radiator&  your  body. This  transmitter  must  not  be  co-located  or  operating  in 

conjunction with any other antenna or transmitter.