6Harmonics Inc GWS-3000 Manual De Usuario
@2013 6Harmonics Inc. All Right Reserved
5
3. FCC Regulatory Information
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
and (2) this device must accept any interference received, including
interference that may cause undesired operation. Any changes or
modifications not expressly approved by the party responsible for
modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Part 15 TV Band Device Notice
This equipment has been tested and found to comply with the rules for TV
bands devices, pursuant to part 15 of the FCC rules. These rules are designed
bands devices, pursuant to part 15 of the FCC rules. These rules are designed
to provide reasonable protection against harmful interference. This
equipment generates, uses and can radiate radio frequency energy and, if
equipment generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. If this equipment does cause
harmful interference to radio communications. If this equipment does cause
harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to
determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
which the receiver is connected.
(4) Consult the manufacturer, dealer or an experienced radio/TV technician
for help.
Caution: Exposure to Radio Frequency Radiation.
To comply with FCC RF exposure compliance requirements, for fixed
configurations, a separation distance of at least 40 cm must be maintained
To comply with FCC RF exposure compliance requirements, for fixed
configurations, a separation distance of at least 40 cm must be maintained
between the antenna of this device and all persons.
This device must not be co-located or operating in conjunction with any
other antenna or transmitter.
other antenna or transmitter.
Only the following components are approved for use with the radio.
• Power over Ethernet Mid-Span: PowerDsine
TM
9001G-40/SP