Z-Wave Europe GmbH ZMEURAZ Manual De Usuario
20
FCC information (additional)
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Co-location warning:
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
OEM integration instructions:
This module has a LIMITED MODULAR APPROVAL, and is intended only for OEM integrators under the
following conditions: As single, non-colocated transmitter, this module has no restrictions in relation to a
safe distance from any user.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
Co-location warning:
This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
OEM integration instructions:
This module has a LIMITED MODULAR APPROVAL, and is intended only for OEM integrators under the
following conditions: As single, non-colocated transmitter, this module has no restrictions in relation to a
safe distance from any user.
The module shall be only used with the antenna(s) that have been originally
tested and certified with this module.
As long as these conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements
required with this module installed (for example, digital device emissions, PC peripheral requirements,
etc.).
Validity of using the module certification:
In the event that these conditions cannot be met, or when installing this module in another host as tested
in this FCC filing, then the FCC authorization for this module in combination with the host equipment is no
longer considered valid and the FCC ID of the module cannot be used on the final product. In these
circumstances, the OEM integrator will be responsible for re-evaluating the end product (including the
transmitter) and obtaining a separate FCC authorization.
Custom design antennas may be used, however the OEM installer must following the FCC 15.21
requirements and verify if new FCC approval will be necessary.
requirements and verify if new FCC approval will be necessary.
End product labeling:
The final end product must be labeled in a visible area with the following:
“Contains FCC ID: 2AAYUZMEURAZ”.
Information that must be placed in the end user manual:
The OEM integrator has to be aware not to provide information to the end user regarding how to install or
remove this RF module in the user's manual of the end product which integrates this module. The end
user manual shall include all required regulatory information/warning as show in this manual.