Cinch Systems Inc RF-CMDWS-319 Manual De Usuario
TX-CXXX Installation Instructions
I-TX-CXXXX Rev.1 Mar 2017
Note: If a low battery alarm occurs, replace
the battery within 7 days.
CAUTION: Battery may explode if
mistreated. Do not recharge, disassemble
or dispose of in fire.
Mounting the Sensor
Mount the sensor using the supplied mounting
screws for permanent mounting installations or
using the supplied double-sided tape is optional.
Note: The gap between the sensor and magnet
should not exceed a maximum of 3/8”.
Mounting Screws
1. Remove the sensor base from the sensor.
2. Place the sensor base in desired location and
mount the base with the supplied screws. Attach
the sensor to the base.
3. Mount the magnet into the desired location
using the supplied screw and lock washer,
making sure the alignment mark lines up with
the sensor mark.
Double-Sided Tape
1. Before applying double-sided tape, ensure
that the desired location is a smooth, clean and
dry surface.
Note: When applying the double-sided tape,
evenly apply pressure to ensure a good surface
contact.
2. Apply double-sided tape to the bottom of the
sensor and the magnet. Mount the sensor and
magnet at the desired locations, ensuring the
alignment marks line up with each other.
For Additional Tamper Security
1. Punch out the tamper cover on the bottom of
the sensor, and using the small screw secure it
to the mounting location, when the sensor is
removed “tampered” the tab remains providing a
tamper condition.
Mount the sensor using the supplied mounting
screws for permanent mounting installations or
using the supplied double-sided tape is optional.
Note: The gap between the sensor and magnet
should not exceed a maximum of 3/8”.
Mounting Screws
1. Remove the sensor base from the sensor.
2. Place the sensor base in desired location and
mount the base with the supplied screws. Attach
the sensor to the base.
3. Mount the magnet into the desired location
using the supplied screw and lock washer,
making sure the alignment mark lines up with
the sensor mark.
Double-Sided Tape
1. Before applying double-sided tape, ensure
that the desired location is a smooth, clean and
dry surface.
Note: When applying the double-sided tape,
evenly apply pressure to ensure a good surface
contact.
2. Apply double-sided tape to the bottom of the
sensor and the magnet. Mount the sensor and
magnet at the desired locations, ensuring the
alignment marks line up with each other.
For Additional Tamper Security
1. Punch out the tamper cover on the bottom of
the sensor, and using the small screw secure it
to the mounting location, when the sensor is
removed “tampered” the tab remains providing a
tamper condition.
Specifications
Model no.
RF-CMDWS - 319
RF frequency
319.5 MHz
Compatibility
Interlogix Learn Mode Panels
and Receivers – Concord,
NetworX and Simon Series
and Receivers – Concord,
NetworX and Simon Series
Battery type
(2) 3-VDC, lithium coin-cell
battery (Varta or Panasonic,
Model CR2032)
battery (Varta or Panasonic,
Model CR2032)
Battery
Varta CR2032
Panasonic CR2032
Panasonic CR2032
Operating
temperature
range
temperature
range
32 to 120°F (0 to 49°C)
Storage
temperature
range
temperature
range
-30 to 140°F (-34 to
60°C)
60°C)
Relative
humidity
humidity
95% non-condensing
Dimensions
(L x W x D)
(L x W x D)
2.25 x 1.0 x 0.50 in.