Conplex International Limited JP5151 Manual De Usuario

 

 

16

 

Any Changes or modifications not expressly approved by the party responsible for compliance 

could void the user's authority to operate the equipment. 

 

This device complies with part 15 of the FCC Rules. Operation is subject to the following two 

conditions: (1) This device may not cause harmful interference, and (2) this device must 

accept any interference received, including interference that may cause undesired operation. 

 

Note: This equipment has been tested and found to comply with the limits for a Class B digital 

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide 

reasonable protection against harmful interference in a residential installation. This 

equipment generates, uses and can radiate radio frequency energy and, if not installed and 

used in accordance with the instructions, may cause harmful interference to radio 

communications. However, there is no guarantee that interference will not occur in a 

particular installation. If this equipment does cause harmful interference to radio or television 

reception, which can be determined by turning the equipment off and on, the user is 

encouraged to try to correct the interference by one or more of the following measures: 

—Reorient or relocate the receiving antenna. 

—Increase the separation between the equipment and receiver. 

—Connect the equipment into an outlet on a circuit different from that to which the receiver is 

connected. 

—Consult the dealer or an experienced radio/TV technician for help. 

 

SAR tests are conducted using standard operating positions accepted by the FCC with the 

phone transmitting at its highest certified power level in all tested frequency bands, although 

the SAR is determined at the highest certified power level, the actual SAR level of the phone 

while operating can be well below the maximum value, in general, the closer you are to a 

wireless base station antenna, the lower the power output. 

Before a new model phone is a available for sale to the public, it must be tested and certified to 

the FCC that it does not exceed the exposure limit established by the FCC, Tests for each 

phone are performed in positions and locations (e.g. at the ear and worn on the body)as 

required by the FCC. 

For body worn operation, this model phone has been tested and meets the FCC RF exposure 

guidelines when used with an accessory designated for this product or when used with an accessory that 

contains no metal and keeping the mobile phone and its antenna at least 1.5 centimeters from your body 

when transmitting. 

 

Non-compliance with the above restrictions may result in violation of RF exposure guidelines.