Fanimation JY1004 Manual De Usuario
Model # JY1004 (with light function)
DC POWER CEILING FAN REMOTE CONTROL MANUAL
□INSTALLATION INSTRUCTIONS
NOTE:
This unit is to be used for the control of
DC power ceiling fan and in an AC120V 60Hz
power supply only. Output Power: 40W (Max.)
for motor and 190W (Max.) for light.
Important: Using a full range dimmer switch
(not included) to control fan speed will damage
the fan. To reduce the risk of fire or electrical
shock, do not use a full range dimmer switch to
control fan speed. (1)JY1004 (2)RC205QBT-D1
is a remote controller embedded with Bluetooth
Module
power supply only. Output Power: 40W (Max.)
for motor and 190W (Max.) for light.
Important: Using a full range dimmer switch
(not included) to control fan speed will damage
the fan. To reduce the risk of fire or electrical
shock, do not use a full range dimmer switch to
control fan speed. (1)JY1004 (2)RC205QBT-D1
is a remote controller embedded with Bluetooth
Module
”CC2541” . It is intend to install with an
electrical fan and aims at switching fan speeds
and lighting.
1. Switch power off at fuse box or circuit
and lighting.
1. Switch power off at fuse box or circuit
breaker before you begin installing the fan.
2.
Make wiring connections as indicated Fig. 1.
3.
Launch distance for remote control: about 10m.
4.
The remote code setting process:
Step: 1 Open the remote battery cover and install 3V,CR2032, 2pcs Lithium batteries,
with the fan power off. (Fig. 2)
Step: 2. Within 30 seconds of restring power to the fan, you must use a ball pen or tool
Step: 2. Within 30 seconds of restring power to the fan, you must use a ball pen or tool
to press
“SET” button about 5 seconds, (Fig. 3). Once the receiver has detected the
frequency, the receiver will make sound, Bi Bi, twice and light flicker twice and turn off.
This will indicate the receiver has learned the frequency that was previously
selected on the transmitter.
Note: After the AC power is on, do not press any other button on the transmitter
before setting learning. Doing so will cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling fan and
light. If the fan is not responding to the transmitter, please turn the power off to the receiver. And repeat step 2.
Note: After the AC power is on, do not press any other button on the transmitter
before setting learning. Doing so will cause the procedure to fail.
After completing the steps above, you should be able to operate the ceiling fan and
light. If the fan is not responding to the transmitter, please turn the power off to the receiver. And repeat step 2.
□LIGHT FUNCTION SELECT SWITCH
If installed energy light onto ceiling fan, please slide the
dip switch
, light
function select switch,
to “O” position. If installed tungsten light onto ceiling fan,
please slide the “light function select switch” to “D” position. (Fig. 4)
□FUCNCTIONS OF REMOTE CONTROL: (Fig. 5)
Indicator LED light: fan speed or light dimmer indicator
button: Tape once turn off the fan. Press and hold this button for 5 seconds to turn on
or turn off the buzzer.
Fan speed:
Turn on the fan and turn speed up.
Turn on the fan and turn speed down.
Light button: Turn on or off the light.
Increase light output level.
Decrease light output level.
(Tungsten only and light function select switch on dimmer position.)
Sleep Timer:
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5